Where does the positive wire go on the starter?

The positive cable connects the positive “+” battery terminal to the starter solenoid. Often, a poor connection at one of the battery cables can cause the starter motor not to work.

Does alternator wire go to positive or negative?

Remote voltage sense alternators: The three wires connected to the alternator are the positive, negative cables and a third smaller gauge wire connected to the alternator remote sense or (S) terminal. To determine if your vehicle has remote sense, voltage will always be present on this terminal at all times.

Where does the black wire go on a starter?

Placement of a Battery Cable on the Starter The short answer is that the red cable connector clamps to the positive terminal, and the black cable clamps to the negative terminal. This will be true whether you’re replacing the battery or the starter.

What gauge is a starter wire?

The battery must be wired to the starter for the starter to work. The wire must be a thick cable, as the starter uses amperage, not voltage, to start. The typical positive battery cable is 4 gauge.

What’s the connection between battery, alternator and starter?

The only wires ran were positive + red in my case 4 gauge wires between battery, solenoid and alternator and a black – negative to chassis ground. Click to expand… In an early OEM wiring harness, the very heavy wire from battery + terminal to solenoid is green. Sounds like you have a red one instead…

Where is the positive voltage wire on a car starter?

The other end of this wire should be connected to the +12V terminal on the backside of the vehicle’s starter, also known as the “positive voltage” connection to the starter. Look for a separate wire with a wire terminal on the end.

Which is side is the positive and negative on starter?

Terminal S is the ingition wire, and terminal B is the pole for the battery cable. The holes for the casing are the ground from the motor to the starter. I hope that this helps you. You can’t post conmments that contain an email address. – Answer the question.

Where does the wire go on an alternator?

This connector is manufactured so it may be inserted into the connector socket on the alternator one way only. If you are able to look at a manufacturer’s diagram of the alternator’s connectors, the wire that slides over Pin 1 of the alternator leads to the positive (+) connection on the vehicle’s battery and senses voltage.

The only wires ran were positive + red in my case 4 gauge wires between battery, solenoid and alternator and a black – negative to chassis ground. Click to expand… In an early OEM wiring harness, the very heavy wire from battery + terminal to solenoid is green. Sounds like you have a red one instead…

The other end of this wire should be connected to the +12V terminal on the backside of the vehicle’s starter, also known as the “positive voltage” connection to the starter. Look for a separate wire with a wire terminal on the end.

Terminal S is the ingition wire, and terminal B is the pole for the battery cable. The holes for the casing are the ground from the motor to the starter. I hope that this helps you. You can’t post conmments that contain an email address. – Answer the question.

This connector is manufactured so it may be inserted into the connector socket on the alternator one way only. If you are able to look at a manufacturer’s diagram of the alternator’s connectors, the wire that slides over Pin 1 of the alternator leads to the positive (+) connection on the vehicle’s battery and senses voltage.