Where can I get a belt diagram?

Where can I find a belt routing diagram for my engine? A: Commonly a belt routing diagram sticker is on the underside of the hood or in the engine compartment. If there is no diagram, make a sketch of the belt and pulleys before removing the belt. This will help you re-route the new belt correctly.

What are the signs of a timing belt going?

Symptoms of a Bad or Failing Timing Belt

• You Hear A Ticking Noise Coming From The Engine.
• Your Car’s Engine Won’t Turn Over.
• You Notice An Oil Leak Near The Motor.
• You Experience Exhaust Issues.
• Your Revs Start Acting Up.

  How do you change the serpentine belt on an Acura TL?

  Using the boxed end of the 14mm combination wrench, turn the tensioner pulley (Figure 1) counter clockwise to allow the serpentine belt can to loosen on the pulleys. Keep tension on the tensioner pulley until the serpentine belt can be removed from a single pulley.

  How big is the Gates belt on an Acura TL?

  For instance, the Gates belt, PN: K060841, indicates the belt is 6 ribs wide and approximately 84″ long. With the new belt in hand, loop the belt with enough of it to fit over the crankshaft pulley. Feed the looped belt down the front of the engine and secure the loop around the crankshaft pulley.

  Where is the tensioner pulley on an Acura TL?

  The easiest pulley to get to is the power steering pulley at the top of the engine. Once the belt is pulled off the first pulley, release the tension on the tensioner pulley. Continue to pull the belt off of the other pulleys until completely removed. Figure 1. Tensioner pulley location. Take the new belt out of the wrapper.

  Using the boxed end of the 14mm combination wrench, turn the tensioner pulley (Figure 1) counter clockwise to allow the serpentine belt can to loosen on the pulleys. Keep tension on the tensioner pulley until the serpentine belt can be removed from a single pulley.

  The easiest pulley to get to is the power steering pulley at the top of the engine. Once the belt is pulled off the first pulley, release the tension on the tensioner pulley. Continue to pull the belt off of the other pulleys until completely removed. Figure 1. Tensioner pulley location. Take the new belt out of the wrapper.

  For instance, the Gates belt, PN: K060841, indicates the belt is 6 ribs wide and approximately 84″ long. With the new belt in hand, loop the belt with enough of it to fit over the crankshaft pulley. Feed the looped belt down the front of the engine and secure the loop around the crankshaft pulley.

  How do you remove power steering pump from Acura TL?

  Remove two 12mm bolts to detach the power steering pump from the engine. Place a rag under the power steering hose, which has the hose clamp. Loosen the clamp on the power steering hose, moving it back onto the hose. Pull the hose from the power steering pump, being careful to spill as little fluid as possible.