Where can I buy an aftermarket tachometer?
Soup up your ride with aftermarket tachometers from AutoZone and enjoy our premium selection, available from some of the most trusted brands in the industry. No matter what type of vehicle you own, AutoZone has you covered with everything from a Dodge Ram tachometer to a tachometer for Chevy Silverado truck.
Can a tachometer be set to work on a 4 cylinder engine?
New tachometers may be set to work on 4-, 6- or 8- cylinder engines by removing the back cap of the tachometer to reveal the cylinder setting switches inside. Set the cylinder switches to match the number of cylinders in your engine. Replace the end cap of the tachometer carefully to avoid pinching any of the internal tachometer wires.
How do you connect a tachometer to a battery?
I connected the black wire to the (-) side of the battery and the red to the (+). Next I clipped the meter wire onto the white wire from the distributor. To be sure it was the right one, I had someone watch the meter as I revved the engine. Be sure to mark or remember the wire for when you come back later.
What should the output switch be on a tachometer?
Most of the time, both switches should be down for a 4 cylinder engine, while both should be up for an 8 cylinder. In a 6 cylinder engine, most of the time the 2 switch should be up and the 1 should be down. If you get a new tachometer, read the instructions to be sure. Locate the output wire from your distributor.
I connected the black wire to the (-) side of the battery and the red to the (+). Next I clipped the meter wire onto the white wire from the distributor. To be sure it was the right one, I had someone watch the meter as I revved the engine. Be sure to mark or remember the wire for when you come back later.
New tachometers may be set to work on 4-, 6- or 8- cylinder engines by removing the back cap of the tachometer to reveal the cylinder setting switches inside. Set the cylinder switches to match the number of cylinders in your engine. Replace the end cap of the tachometer carefully to avoid pinching any of the internal tachometer wires.
How to install an Auto Meter tach adapter on your Mustang?
After you cut all 8 coil powers, use a 16g wire and link all the power (harness side) cut halves together, then hook to the solid red of the 9117 tachometer adapter. Next, use 16g wire and link all the coil-side cut halves together and hook to the red wire with a green stripe of the 9117 tachometer adapter. Ground the black 9117 adapter wire.
How much does it cost to install a tachometer in a car?
Getting Started Get a tachometer and splicing connectors. You can either buy a tachometer new, which usually run somewhere between $30 and $50, or salvage on old one for relatively cheap and install it into your car. Adjust the tachometer for the number of cylinders in your engine.