Where are the fuse panels on an Acura TSX?

Here you will find fuse box diagrams of Acura TSX 2009, 2010, 2011, 2012, 2013 and 2014, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout).

Where is the fuse box on a Honda Accord?

The under-hood fuse box is on the driver’s side. Amps. It is located under the dashboard on the driver’s side. Amps. The passenger’s side interior fuse box is on the lower passenger’s side panel. To remove the lid, put your finger in the notch on the lid, and pull it upward slightly, then pull it toward you and take it out of its hinges. Amps.

What does HandsFreeLink do on an Acura TSX?

HandsFreeLink Control Unit (2006-2008), Accessory Power Socket Relay, Audio Unit (Audio-HVAC Display Module), Navigation Display Unit (Audio-HVAC Display Module), Navigation Unit, Shift Lock Solenoid (A/T), Audio Amplifier, Multiplex Integrated Control Unit (MICU)

Where is the fuse box on an Acura TSX?

Fuse box diagrams (layout, location, function, assignment) in the cabin and engine compartment of Acura TSX (CL9; 2004, 2005, 2006, 2007, 2008). If something electrical in your vehicle stops working, the first thing you should check for is a blown fuse.

What is the sensor on an Acura TSX?

Air Fuel Ratio Sensor (Sensor 1), Evaporative Emission Control (EVAP) Canister Vent Shut Valve (2006-2008) Combination Switch Control Unit, Gauge Control Module, Immobilizer Control Unit-Receiver, Imoes Unit.

Here you will find fuse box diagrams of Acura TSX 2004, 2005, 2006, 2007 and 2008, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout). Cigar lighter / power outlet fuse in the Acura TSX is the fuse №9 in the Passenger compartment.

When did the first Acura TSX come out?

In this article, we consider the first-generation Acura TSX (CL9), produced from 2004 to 2008. Here you will find fuse box diagrams of Acura TSX 2004, 2005, 2006, 2007 and 2008, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout).

How can you tell when a fuse has been blown?

You might be wondering, then, how to tell if a fuse is blown–an actual fuse, that is. You will see that the fuse has melted, and there might be charring on the panel. A true fuse typically consists of a piece of metal, most commonly an encased wire, that actually melts when overheated. This is what stops the fault (aka “short” or “power surge” ).

What causes a circuit breaker to blow a fuse?

Any faulty wiring or connected parts risk a power fault (surge), which trips a circuit (or blows a fuse). So, again, the problem is not that the circuit breaker (or fuse) didn’t do its job but rather that there was faulty equipment.

Where is the fuse on a car alarm?

Find the alarm fuse in the fuse box. Remove it, and put the fuse in a plastic bag. You can store it in your glove compartment for safe keeping. If you cannot locate the alarm fuse right away, remove fuses to see if the alarm will stop.

Fuse box location. The under-hood fuse box is located near the back of the engine compartment on the driver’s side. The interior fuse box is on the driver’s lower left side. To remove the fuse box lid, put your finger in the notch on the lid, and pull it toward you and take it out of its hinges.