When to replace Acura Legend ABS control module?

When to replace Acura Legend ABS control module?

For optimum performance from your Legend ABS Control Module, you should check this unit regularly, and replace it when it’s not working properly. Yet the time will always come that either of the auto parts and accessories making up the vehicle must be removed and replaced with a new one.

Do you need to rebuild an ABS unit?

We retain all original programming during the rebuild process so no need for additional programming work when you receive your unit back. We test supply and rebuild all modern automotive ABS units that comprise of an ABS module, pump, Hydraulic unit and motor. Below is a list of common failing ABS pumps.

What causes the ABS warning light to remain on?

Very common fault causes the ESP light to illuminate with fault code “01435 Brake Pressure Sensor 1 (G201)”. This commonly failing Volkswagen Passat ABS pump and module will cause the ABS warning light to remain on. Usually communications to the module is not possible…

What causes ABS pump to fail on ate Mk60?

Failure of the Internal Brake Pressure Sensor is a very common fault for all vehicles fitted with the ATE MK60 ABS unit fitted with the internal brake pressure sensor… Common failing ABS pump that causes the ABS / EBD failure message to show and the speedometer to fail.

What kind of ABS system does Acura have?

On the same year Honda Accord, the control module is located behind the rear seat on the passenger side. The Sumitomo ABS system in the 1992 Acura models is a four-wheel ABS system with wheel-speed sensors at each wheel. But it’s a three-channel system that controls both rear wheels as a pair.

Why does my Acura ABS light keep coming on?

Common symptoms that you may notice when there is a problem with the Acura ABS: Wheels may lock and slide when braking. Common problems that trigger the ABS light to stay on: To reset the ABS light on an Acura, you first need to read the codes with an ABS scanner.

When did Honda start using an ABS system?

In fact, one of Honda’s earliest ABS applications dates back to 1988 on the Acura Legend. The majority of new models are using Teves ABS systems. One of the systems used during the 1990’s was the Sumitomo ABS system, which was used on the 1992 Acura Integra, Legend and Vigor models, and Honda Accord.

What are the ABS specs on a 1992 Acura?

Refer to a manual for the exact specs, but as a rule the front sensors on the 1992 Acura applications should read 750 to 1,200 ohms, and the rear sensors 1,100 to 1,600 ohms. If a wheel-speed sensor’s resistance is within normal range, remove the sensor and inspect it for damage or metallic debris sticking to the tip.