What to do when your convertible top stops working?

By the time your convertible top stops working, the leaks should be easy to identify. Inspect the hydraulic lines. Make sure they are tightly connected. The hoses should not be cracked or leaking. Address any leaks that you may find at the pump, cylinders, or solenoid. Replace any damaged or leaking o-rings.

Where is the top motor on a convertible?

If the level drops below the MIN, the convertible top will either not operate at all or move too slowly, not close, or stop halfway. Locate the convertible top motor. In most convertibles, it is located in the trunk behind the lining. Also, check near the spare tire or behind the rear seats.

Why is Max not marked on convertible top?

MAX, in some cases, is not marked because it is the same as the fill hole. You can’t fill them past the filler hole since the fluid will leak out, which is by design. Suppose the fluid level is too low the convertible pump operation completely to protect the motor and the hydraulic system components.

Can a CarGurus convertible roof not go down?

– CarGurus Convertible roof will not go down (stops halfway!) Purchased used bmw 325ci with 16,000 miles. Top worked when I purchased but broke about a month later Had repaired twice (by different garages). Works for 2 to 3 weeks then breaks again.

Why does my Mercedes convertible not go up or down?

Mercedes Convertible Top Won’t go up or down. Convertible top moves very slow. This can be caused by low fluid level or air in the hydraulic lines. Air in the hydrauilc lift cylinders. It can be caused by binding of mechanical arms. Weak convertible top lift cylinder. Weak battery or ground connection.

What should I do if my steam update is stuck?

Step 1: Right-click the shortcut icon or executable file of your Steam and choose Properties. Step 2: In the pop-up window, check Run this program as an administrator option. Step 3: Click Apply and OK button to save the change. Then, you can launch your Steam to check if it can update properly.

What to do when you get stuck on Welcome Screen?

Press the Shift key present on the keyboard and simultaneously tap on Restart in the menu present above the Power button. Step 2: Tap on the Troubleshoot option present in the menu of Advanced Recovery Options displayed on screen. Now tap on “Advanced Options”. Step 3: Lastly, tap on the Startup Repair option.

How can I tell if my convertible top is leaking?

You can visually inspect all the cylinders for leaks by manually opening and closing the convertible. At first, the leaks will be minor, but they will worsen over time, and you will eventually see leaks on the trunk floor or a stained convertible top.

Is there a problem with the roof on an Audi?

Fast forward several months and it’s time to look at the roof problem. The seller had included an Audi parts box with a boot lock motor but I gathered had not fitted it yet.

What are the switches on a convertible top?

These switches relate to Convertible top released switch -F205 closed (convertible top locked) & Convertible top front latch switch -F172 closed (convertible top resting on roof frame). Zone 2 inputs are ignored.

How many volts does a convertible top need?

Every time you press the convertible switch, you should read between 11-13 volts at the pump. If you are not getting any current at the hydraulic motor, you may have an electrical problem or a defective switch. There are between 4 and 10 micro-switches installed in your convertible required to run your top.

How does a convertible roof open and close?

A single motor connects to two cables and drives a leveraged gear mechanism that raises the rear of the roof, then raises the rear convertible lid, and then folds and tucks the top away. When your roof is not opening or closing correctly, then one or more of the components in the mechanism are probably worn out or damaged.

What to do when convertible top does not close?

If the top does not close all the way using the automatic controls, it must be manually reset. The E46 should be at a complete stop when the convertible top is being opened or closed in order to prevent the mechanism from becoming damaged. Press down on the emergency lock button, located between the rear seats.

What’s the problem with the C6 convertible top?

Seems there is a microswitch on the #3 top bow that tells the computer the state of the top. They ordered a new switch from GM. Problem is the switch does not come with an actuating arm (which fell off into a black hole, never to be found). Now they start searching and end up finding a new harness on E-bay.

What causes a convertible top to lock up?

The most common problems, in order of occurrence, are: Frozen pump: Broken or maladjusted tray fold switch: Burned-out relay: Low fluid level in the pump reservoir: Worn pump “O-ring: Poor ground: and Weak battery. (Pictures of 63) TOP DOWN HOW TO GET A LOCKED TRUNK OPEN

Why do I need to Reset my E46 convertible top?

The top needs to be fully closed to prevent water from entering the vehicle during wet weather. If the top does not close all the way using the automatic controls, it must be manually reset. The E46 should be at a complete stop when the convertible top is being opened or closed in order to prevent the mechanism from becoming damaged.

Why are the diaphragms not moving when the booster is opened?

If the engine vacuum pulling on the diaphragms within the booster is less than that of atmospheric pressure, when the two-way valve opens, there isn’t a way for the diaphragm to move as the booster almost stays in the at rest position because the difference between the front and rear is not enough to make the diaphragms to move.

What should I do if my HDD starts up and then stops?

To replace the PCB, you have to get the same exact HDD model and remove it, and replace it. This usually results in having 2 failed HDD’s especially if you have never tried this before. It is normal for a drive to spin up, and then down if it is an external drive and it has no data connection.

What does it mean when a hard drive stops spinning?

Upon powering up it starts to spin up. However after about 10 seconds, the drive stops spinning completely. Same thing happens after multiple attempts. So it sounds like to me it is dead, right? (Just want second opinion) So if in fact it is dead, I read from several online forums and guides that replacing the PCB to the HDD MIGHT fix it.

What kind of hydraulic system does a convertible have?

Convertible tops can seem complicated, but the hydraulic system is straightforward, regardless of what make and model you have. All hydraulic convertible top systems function practically the same, whether you own a Mercedes-Benz convertible or a Mazda, Chrysler, Toyota, Porsche, BMW, or Lexus.

What kind of fluid does a convertible top use?

One of the most commonly used convertible top fluids is the Pentosin CHF 11S. Use a digital multimeter to check the lines feeding the convertible top motor. Every time you press the convertible switch, you should read between 11-13 volts at the pump.

What should I do if my convertible top is not opening?

Press and hold the central lock toggle switch in UP position for 5 seconds. This will start the opening process. 4) If still no luck, checked the fuses (there are two) powering the roof. 5) It could be that the battery is weak – the opening process needs a lot of power. Try to charge the battery or install a new battery.

What to do if your Mercedes convertible is not working?

Check the convertible top relay as well. Swap it with a known working relay that is identical. You can also bridge the top relay for a couple of seconds to see if the hydraulic pump start to run. Replace the convertible top relay if necessary, PN 0025421319. Next, check the micro switch where the divider locks.

What causes a convertible top to move slowly?

Convertible top moving very slowly. Often caused by a weak lift cylinder. It can also be caused by binding or convertible motor failure. If a convertible system may seem complicated at first, don’t let fear stop you from carrying a few basic troubleshooting steps yourself.

Where is the motor located on a convertible top?

The motor is located in the mid bar across the roof, and is hold by 3 torx T25 screws. Remember to lubricate the moving parts so the new motor will not get hurt. Then, the second part: The complete open function will not start – it stops after the sunroof has been opened, and the LED at the open button will start to flash, and it freezes.

Which is the fastest Corvette of all time?

At the time, this was the fastest, best-handling and most developed Corvette. Zero-to-60 times were in the sub-5-second range, and skidpad handling approached 1g—excellent numbers even for today. It was also the most fuel-efficient Corvette ever.

When did the C5 Vette corvette come out?

The C5 Vette was launched in March of that 1997. It was a clean-slate rethink of the Corvette formula: two seats, composite body, pushrod V8 and independent suspension.

Who was the body engineer for the corvette?

In calendar years 1952 and 1953 Chevrolet produced nearly 2 million steel bodied full-size passenger cars and the intended production volume of 10,000 Corvette for 1954 was only a small fraction of that. The body engineer for the Corvette was Ellis James Premo.

Can a convertible top be installed on a corvette?

Full restoration of Corvette convertibles is very widespread as Corvette Sting Rays and other Corvette convertibles are now classics. The Corvette convertible top can be installed by the do-it-yourself owner if a good convertible top installation manual is available (and we supply the top install manual where available.)

What kind of top does a Chevy Corvette use?

Every Corvette convertible top is available in original fabrics and colors and also in alternative convertible top fabrics and colors. The Chevrolet Corvette convertible top fabric was originally pinpoint vinyl for the fifties and sixties Chevy Corvettes. Later Corvettes included Targa tops.

Is there a replacement top for a Corvette Sting Ray?

Replacement Corvette tops, made to original patterns, are available in all original fabrics. Soft top fabrics are described in the ‘Help’ section of our home page. Full restoration of Corvette convertibles is very widespread as Corvette Sting Rays and other Corvette convertibles are now classics.

What do I need to restore a corvette top?

Hold down cables, pads and other accessories, in addition to the tops and headliners are offered. Full convertible top restoration packages, including tops, cables and top pads are listed. Please select your Corvette convertible from the list at the right.