What is VSA on Acura RL?
The vehicle stability assist (VSA) system helps to stabilize the vehicle during cornering if the vehicle turns more or less than desired. When VSA activates, you will see the VSA activation indicator blink. There may also be some noise from the modulator.
Is the VSA light the same as the triangle light?
The Vehicle Stability System also uses the same wheel speed sensors, so the VSA light will also come up. The Triangle is a master warning light that comes on with any others just to get your attention.
How to check engine light and VSA light?
The only way to fix this… You should first lift wheel off the ground and support it. Then try wiggling the tire up and down or side to side to see if you feel any looseness in the wheel bearing and hub. Then spin the wheel… It is not advisable to drive your vehicle without the serpentine belt attached.
What does it mean when your car says SH AWD?
When the SH-AWD error pops up, the monitor is showing that the car goes to FWD. Other than that, everything else drives fine, so I’m thinking it’s a sensor issue or it’s taking forever to get the bad gas out of the system. Trying to see if anyone had this problem before and if I should have it rediagnosed at the dealer.
Why do I get Shawd warning on my Acura MDX?
They determined the EGR valve was bad and changed it out. They also pulled the manifold and cleaned the air ports leading to it. They were confident their work would fix both the Check Emissions and SHAWD warnings. So far they seem to have been correct. Here’s hoping I can stay warning free for a while.
What does the VSA light mean on an Acura RDX?
The light listed simply as VSA is the system indicator light. If it stays on, it is letting you know that there is some problem with the RDX’s VSA itself. When the light comes on, Acura suggests getting someplace safe and restarting the engine.
Why does the VSA light stay on all the time?
If this light stays on at all times, it probably means that the VSA system has been switched off. This is easy enough to do, there is a button that says VSA on it. Just press it and see if this light turns off.
When the SH-AWD error pops up, the monitor is showing that the car goes to FWD. Other than that, everything else drives fine, so I’m thinking it’s a sensor issue or it’s taking forever to get the bad gas out of the system. Trying to see if anyone had this problem before and if I should have it rediagnosed at the dealer.
They determined the EGR valve was bad and changed it out. They also pulled the manifold and cleaned the air ports leading to it. They were confident their work would fix both the Check Emissions and SHAWD warnings. So far they seem to have been correct. Here’s hoping I can stay warning free for a while.