What is the service code B1 on Acura TL?

B1 services cover basic maintenance tasks including, but not limited to, the following: Engine oil and filter change. Front and rear brake inspection. Parking brake adjustment (as needed)

How do I reset my Acura CODE?

Device Display

1. Turn the ignition switch to ON.
2. Turn ON the device and confirm that the display reads CODE.
3. Turn OFF the device.
4. Press and hold the 1 and 6 radio preset buttons and turn ON the device.
5. The first screen displays a U and the first four digits of the serial number (for example, U2200).

How to change automatic transmission fluid in an Acura TL?

Acura TL 2009-2014: How to Change Automatic Transmission Fluid Step 1 – Remove the plastic undertray. Warm up the motor/transmission with a 15-minute drive, and be sure to put the… Step 2 – Loosen the ATF fill cap. Before you drain the old fluid, it is a very good idea to make sure you can get …

Where is the drain plug on an Acura TL?

The drain plug is a 3/4-inch square recessed head. You can use a 3/4-inch drive ratchet without a socket attached, or a 1/2-inch or 3/8-inch to 3/4-inch socket adapter to remove it. The drain plug is found underneath the transmission on the passenger side. This plug can be hard to remove, so you may need to use a breaker bar to gain more leverage.

Where is the ATF cap on an Acura TL?

With a 17mm socket on a long extension, loosen (but don’t remove) the ATF filler cap. This cap is labeled “ATF” and located on the driver’s side of the engine compartment close to the fire wall, but inconveniently tucked under two hoses.

Where is the transmission dipstick on an Acura TL?

Then, with the engine off, check the transmission dipstick again, and top off the fluid to get its level line between the marks on the dipstick. The transmission dipstick is located under the hood, conveniently at the front of the engine compartment on the driver’s side.