What is the name of the PassLock module?
PASSLOCK MODULES HAVE MANY NAMES INCLUDING ANTI-THEFT MODULE, VATS MODULE, AND PASSLOCK, BUT THEY ALL REFER TO THE SAME PART. THIS COMPONENT’S JOB IS TO TELL THE ELECTRONIC ENGINE CONTROL MODULE (ECM) THAT THE CORRECT KEY IS BEING USED TO START THE VEHICLE.
How to permanently disable GM PassLock system Hilux Motors?
5.Take your digital ohm meter and put your negative probe on the black wire that you stripped back earlier. Put the positive probe on the yellow end of the wire that leads BACK to the ignition. Use alligator clips here to help the probes grab the wires. 6.With the probes hooked up turn the ignition to the run position.
Where are the pass lock wires on a Hilux?
1.Remove the appropriate dash panels to get to the wire harness. 2.Locate the Pass Lock 2 Wires, they will be coming out of the ignition OR on the BCM they will be located in the grey connector, Pin A6 is your yellow wire, and pin B6 will be a black wire (they should be right beside each other).
What to do when your PassLock security light goes out?
The Body Control Moudle should re-learn the security signal, and the “SECURITY” light should go out. When it does, Turn the ignition OFF for five (5) seconds, and then try to re-start the car. The “SECURITY” light should remain off this time, and the car should keep running. If not, don’t give up.
PASSLOCK MODULES HAVE MANY NAMES INCLUDING ANTI-THEFT MODULE, VATS MODULE, AND PASSLOCK, BUT THEY ALL REFER TO THE SAME PART. THIS COMPONENT’S JOB IS TO TELL THE ELECTRONIC ENGINE CONTROL MODULE (ECM) THAT THE CORRECT KEY IS BEING USED TO START THE VEHICLE.
5.Take your digital ohm meter and put your negative probe on the black wire that you stripped back earlier. Put the positive probe on the yellow end of the wire that leads BACK to the ignition. Use alligator clips here to help the probes grab the wires. 6.With the probes hooked up turn the ignition to the run position.
1.Remove the appropriate dash panels to get to the wire harness. 2.Locate the Pass Lock 2 Wires, they will be coming out of the ignition OR on the BCM they will be located in the grey connector, Pin A6 is your yellow wire, and pin B6 will be a black wire (they should be right beside each other).
Where is the PassLock code located on a GM car?
An antenna located at the entry point of the ignition lock cylinder reads the transponder data from the key and sends a code to the Passlock control module. This system is very similar to the immobilizer system used by many other manufactures.