What is the difference between crankshaft and camshaft sensor?

What is the difference between crankshaft and camshaft sensor?

The crankshaft position sensor monitors as a multifunctional sensor used to set ignition timing, detect engine RPM and relative engine speed. The camshaft position sensor is used to determine which cylinder is firing to synchronize the fuel injector and coil firing sequence.

Can you drive with a bad camshaft sensor?

Yes, it is safe to drive with a bad camshaft sensor. However, the performance of your engine will not be as good and fuel consumption may increase. In some cases, the camshaft may need replacement if there are any other symptoms of failure on this component.

Where is the camshaft position sensor located on a car?

The camshaft sensor is located near the crankshaft and is positioned above the cylinder head of the engine. Since the sensor is easily accessible and no other part needs to be removed to reach it, installing a new sensor is also easy. As soon as the old camshaft position sensor is located, you must remove it.

Where is the camshaft sensor on a 3800 V6?

On the 3800 V6, the camshaft position sensor is located behind the water pump pulley. If you were to look at the pulley straight on, it is at about the 9 o’clock position.

What does a camshaft sensor do in an Audi A4?

On Three Wire Sensor engines, the Camshaft Position (CMP) sensor is a variable reluctance sensor, which is triggered by the high-point mark on one of the camshaft sprockets. The Distributor engine does not use a separate CMP sensor. It utilizes a conventional distributor, equipped with a Hall effect device, for this function.

Can a bad camshaft sensor shut down an engine?

Without this information, the engine would not be able to function properly. Over time, the camshaft position sensor can fail, or become worn down, due to accidents or normal wear and tear. There are a few warning signs to watch out for before your camshaft position sensor completely fails and shuts down the engine, making replacement a necessity.

Where is the camshaft position sensor on a GM car?

Look around the top section of the timing belt/chain cover (in the front of the engine) or at the rear end of the cylinder head. Some GM models may have a special compartment for the sensor.

What kind of camshaft do I need for a Chevy Cavalier?

New Lifters should be changed out. Listen to our Stage 3 Camshaft in Action!!! This cam is designed for the Oval Track Racer only, for tons of power gain and high rpms, must have 11+ compression (the higher the better), requires our Beehive Springs #12-001 or #12-002, for the correct spring pressures. Stock retainers and locks can be used.

Where is the crankshaft sensor on a 3.1L V6?

Late 3.1L and 3.4L V6 engines use 2 crankshaft position sensors. One is located behind the crankshaft pulley on the front of the engine and the other is the same one described above.

How can I tell if my camshaft sensor is failing?

If your vehicle idles roughly, stalls frequently, has a drop in engine power, stumbles frequently, has reduced gas mileage, or accelerates slowly, these are all signs your camshaft position sensor could be failing.