What is P0446?

What is P0446?

Code P0446 indicates that there is an improper voltage drop in the EVAP Vent Valve circuit, which can be caused by either too little or too much electrical resistance. This improper electrical condition will cause the vent valve to malfunction.

What does the code p0449 stand for?

Code P0449 Definition Evaporative System (EVAP) Vent Control Circuit Malfunction Code P0449 Meaning The Evaporative Emission Control (EVAP) System seals the fuel system of the vehicle in order to prevent fuel vapors from the fuel tank and fuel system from escaping into the atmosphere.

What causes a p0449 GMC to leak?

P0449 GMC Possible Causes. Vacuum leaks, damaged hoses or improper routing. EVAP system. Check fuel cap, canister, valves or components. Faulty purge or vent solenoids. Check connector and wiring. Fuel saturated vapor canister.

What are the p0449 codes for lean Bank 2?

The codes I,m getting are p0174 system to lean bank 2, p0452 evap system pressure sensor switch low, and p0449 evap system vent valve solenoid circuit. Are all these codes relate… Need more help with a p0449 code?

What does the generic powertrain code p0448 mean?

This code is a generic powertrain code. It is considered generic because it applies to all makes and models of vehicles (1996-newer), although specific repair steps may vary depending on the model.

What is p0449 code Hummer H3?

Hummer H3 P0449 Definition P0449 is a universal OBDII trouble code . This means that regardless of which make or model of vehicle, the code will mean the same thing (H3 or not, as long as it was manufactured after 1996). P0449 indicates that the valve or solenoid circuit that controls the evaporation system is not functioning properly.

What is code p0449 in Uplander?

The P0449 in Uplander is a fairly straight forward code pointing to a problem with the EVAP Vent Solenoid. The Vent Solenoid is located on top of the fuel tank.

What does po449 mean?

Your Po449 code means: Evaporative Emission (EVAP) Vent Solenoid Control Circuit. Check to see if anything on you EVAP system has gotten disconnected and make sure that none of your hoses have gotten old and bridle or have holes.