What does it mean when your car turns over but wont start?

When your engine cranks but won’t start or run, it could mean your engine is having trouble producing a spark, getting fuel, or creating compression. The most common causes are problems in the ignition (for example, a bad ignition coil) or fuel system (for example, a clogged fuel filter).

What would make a fuel pump not work?

If the fuel pump is not coming on, and the fuse and relay are good, then it may be possible that there is a problem with the pump or the fuel pump circuit. If it is not then there may be some sort of wiring issue before the fuel pump relay, perhaps a wiring issue or other problem with the ignition switch.

Will my car start if the fuel pump is bad?

If your vehicle’s fuel pump cannot get gas from the tank to the engine, you will have trouble starting your car. The car will struggle to start and run because the pump cannot push enough gas through. A worn pump loses its pressure and the engine is being starved of gasoline.

What to do when your engine has no spark?

Insert a spark plug tester into the plug boot and ground it on a piece of metal on the engine. Finally, Have someone crank the engine and watch for spark. Remove one of the coils from the spark plug. Use an extra spark plug. A spark plug tester. Or even a screwdriver in the end of the coil.

When do you need to replace spark plugs?

Modern vehicles can go a long time without needing new spark plugs. However, once the car hits about 100,000 miles, it’s often wise to replace them. Failed spark plugs can create a long list of performance issues, such as misfiring, rough idling, trouble accelerating, poor fuel efficiency and an illuminated Check Engine Light.

Why is my car sputtering after new spark plugs?

It is possible for there to be a vacuum leak, a faulty oxygen sensor, a catalytic converter that is starting to show signs of failure, or even a possible problem in the fuel system. It will be necessary to do some further diagnostics to determine which system is causing the problem, and then figure out which part in that system is the root cause.

Why is there no spark in my ignition?

An ignition module requires some type of external input in order to activate. If your vehicle stalls unexpectedly during operation and will not start again, it is likely because of loose or corroded electrical connections in the ignition module. In this case, check the switch, clean oxidized terminals, and replace broken wires if necessary.

Why does my ignition coil not have a spark?

If the ignition coil has spark, there must be a problem with the distributor or the wiring between the ignition coil, distributor, and spark plugs. Replace all three. If the ignition coil does not have spark, it’s time to check its wires. Use a test light to check the continuity on the signal wire and power wire on the ignition coil.

Why does my car not start when I Turn on the ignition?

If no, the problem could lie in the spark plug cables, the distributor (if you have one), or the ignition coil. Most modern cars do not have distributors. Instead, each plug wire has its own coil. Sometimes the coil is attached to the plug wire, other times, they are located in a block called a coil pack.