What causes P2004 code?

Code P2004 is typically caused by one of the following: A failed IMRC actuator. A problem with the intake manifold or linkage. Wiring issues.

Can I drive with code P2004?

Can I drive with a P2004 trouble code? As long as you are not experiencing difficulties with the way the engine is running, then yes, you can keep driving until you can get this repaired.

Is a P2004 code bad?

The Danger If You Do Nothing For the most part, the biggest danger of this error code is poor performance and fuel efficiency. If your cylinder head has all the cylinder valves connected, then your engine may not run at all. The problem with one cylinder may be causing all the cylinder not to fire.

What does code P1537 mean?

Ford DTC P1537 Make: Ford Code: P1537 Definition: Intake Manifold Runner Control Malfunction (Bank 1 Stuck Open) Description: Key on or engine running; and the PCM detected the Bank 1 IMRC Monitor signal was less than its expected calibrated range at closed throttle (it may be stuck in open position).

What does a Imrc do?

The intake manifold runner control is an engine management component that is found on newer intake manifold designs. It is usually a motorized or vacuum actuated unit attached to the intake manifold, that controls the opening and closing of butterfly valves inside of the intake manifold runners.

What does code p2005 in OBD II mean?

A stored code P2005 in your OBD II equipped vehicle means that the powertrain control module (PCM) has detected that the intake manifold runner control (IMRC) actuator for engine bank 2 is stuck in the open position. Bank 2 denotes that the problem has occurred in the bank of the engine that does not contain cylinder #1.

How can I Fix my P2004 Audi intake manifold?

A position sensor can be fixed to the control circuit to monitor the valve for both electrical and mechanical faults. An actuator test can be performed to test the circuit and live data or an oscilloscope can be used to validate the position feedback. Need more information on how to fix the P2004 AUDI code?

How much does it cost to repair a P2004 Audi?

The cost of diagnosing the P2004 AUDI code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. Need more information on how to fix the P2004 AUDI code? Need more help?

What was the p2005 code on a 2005 Subaru WRX?

2005 SUBARU WRX 2.5 TURBO CODE P2005 INTAKE MAN. RUNNER STUCK OPEN BANK2 I JUST REPLACED THE CLUTCH ON A WRX W/TURBO, OAT ABOUT 10 MIN. INTO THE TEST DRIVE THE WRX THREW A P2005 CODE OUT, INTAKE MANIFOLD RUNNER STUCK OPEN.