What can cause a P0118 code?

What can cause a P0118 code?

The onboard diagnostic (OBD) code P0118 is an Engine Coolant Temperature Circuit – High Input malfunction. This code refers to the engine coolant temperature (ECT) sensor. The code is also set if the PCM determines that the ECT sensor resistance is out of specification.

What are the symptoms of a bad engine coolant temperature sensor?

Symptoms of a Bad Coolant Temperature Sensor If your vehicle starts to use a lot more gasoline than usual, or black smoke is starting to come from the exhaust pipe, these are indicators that the coolant temperature sensor in your vehicle could be defective, and needs to be replaced.

What would cause a coolant sensor to go bad?

The engine may run in fail-safe mode: Many Check Engine light codes related to the (ECT) sensor; could also be caused by other reasons. Such as a bad thermostat or issues with the cooling system; including even a leaking head gasket.

What does the p0118 code do on a car?

The P0118 code will put the engine ECM to go into a failsafe mode, which may cause the engine to run rough, or hesitate until the engine warms up to operating temperature.

How much does it cost to repair an Acura p0118?

Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P0118 ACURA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Where is the coolant temperature sensor located in a 2003 Acura?

The P0118 code is for the Coolant Temperature Sensor and the P1791 for the Vehicle Speed Sensor, but neither of the two sensor should cause the no crank problem. The coolant temperature sensor could cause a hard start, but the engine should start. Read more: https://www.autocodes.com/p… Where is the temperature sensor located in a 2003 acura.tl

Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P0118 ACURA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

What does the ECT code p0118 mean?

Code P0118 is the result of the ECT sensor indicating a high voltage input from the coolant temperature circuit. (typically over 4.7V) What Are the Symptoms of Code P0118?

What is the OBD code for an Acura check engine?

P1201Cylinder 1 Misfire – Compare possible causes/symptoms for this Acura check engine light code to the Generic OBD II code P0301 P1202Cylinder 2 Misfire – Compare possible causes/symptoms for this Acura check engine light code to the Generic OBD II code P0302

The P0118 code is for the Coolant Temperature Sensor and the P1791 for the Vehicle Speed Sensor, but neither of the two sensor should cause the no crank problem. The coolant temperature sensor could cause a hard start, but the engine should start. Read more: https://www.autocodes.com/p… Where is the temperature sensor located in a 2003 acura.tl