What are the symptoms of an Acura transmission malfunction?

Common symptoms that you experience when Acura transmission malfunctions: 1 Vibration while driving 2 Hesitation upon acceleration 3 Delayed shifting 4 Growling or grinding noise 5 Weak acceleration or no power 6 Transmission jerking 7 Check Engine Light on (P0700, P0730, P0740, P0780, P1768) 8 Erratic shifting 9 Loss of power while driving

What to do if your Acura is stuck in gear?

If your Acura is stuck in gear or you notice a delay in shifting, the first thing that you need to do is check the transmission fluid level. Do not drive an Acura with low transmission fluid.

How to check the transmission fluid in an Acura?

Check Transmission Fluid Level 1 Remove the transmission dipstick and ensure there is transmission fluid. Do not continue with the next steps if there is no transmission fluid at all. 2 Drive your Acura around for at least 15 minutes. 3 Remove the transmission dipstick and determine the fluid level. 4 Add transmission fluid. …

Why are the solenoids on my Acura not working?

Multiple solenoids are mounted on the valve body of the Acura transmission. Due to age, these solenoids can fail or get sticky, causing erratic shifting. Sensors mounted on the valve body can get dirty or stop working if there is a short in the wire harness. It is possible to overhaul the valve body instead of replacing it.

Why is my Acura not moving out of Park?

It can be scary if your Acura shifter won’t move out of Park. Not only are you stuck in a parking lot or garage, but now you are worried about an expensive car repair. A bad brake light switch typically causes the problem, or the ignition switch is not releasing the shifter from the park.

Where is the diagnostic port on an Acura?

To diagnose Acura transmission problems, it is recommended to use an OBD2 scanner for Acura Honda Transmission. Locate the diagnostic port under the dashboard on the driver’s side. This is a 16-pin port.

What kind of problems does an Acura TL have?

The interior accessories issues continue to focus on the cracked dashboard, the CD and tape player breaking, and rattling in the rear shelf behind the rear seat. The cracked dashboard has a common solution of replacing the dashboard and having a typical repair cost of around $1,700 at around 89,000 miles.

What’s the most common problem with an Acura?

By matching owner complaints with recall, investigation and technical service bulletin data we’ve come up with a list of the most common Acura problems for every model and generation. We’ve even ranked vehicles by their reliability. A few problems that keep popping up. There’s plenty more where that came from.

What’s the problem with the Acura Pu 15?

The lawsuit points to TSB #PU-15-34 where Acura says a driver may not be able to select any other gears until the vehicle is restarted due to an open circuit in the actuator supply. Acura said a simple software update would fix the problem. But according to the plaintiffs it didn’t work.

Why does my Acura MDX hesitate when accelerating?

According to Car Complaints, a class-action lawsuit has been filed by a group of Acura MDX and Acura RDX owners claiming their vehicles suffer hesitation when accelerating because of defects that have existed since the day they rolled off the production line.

Are there any problems with the Acura J series?

Acura owners with V6 J-Series engines better think again. Sorting out which topics, problems, and model years have the most overall complaints from owners on CarComplaints.com. Some models just can’t seem to get out of their own way.

Why is my Acura not shifting between gears?

When this happens, your Acura transmission will delay shifting between gears in upshifting and downshifting. To fix this problem often a new torque converter is needed.

How long does it take to change transmission fluid in Acura?

Drive your Acura around for at least 15 minutes. Make sure to shift the transmission between all the gears if necessary manually. This will allow your Acura transmission fluid to reach operating temperature. Remove the transmission dipstick and determine the fluid level.

If your Acura is stuck in gear or you notice a delay in shifting, the first thing that you need to do is check the transmission fluid level. Do not drive an Acura with low transmission fluid.

Are there any problems with the Acura clutch pack?

Read fault codes via the OBD2 port located under the dashboard using an OBD2 scanner. Another problem that can affect some Acuras is that the 3rd gear clutch pack may wear prematurely. If this happens, you may have issues upshifting or downshifting in 3rd gear.

What to do if your Acura has a misfire?

We replaced that with a bolt and gasket (washer) from Acura (PN 90009-R70-A00 and 94109-14000 if you were curious). After all of this work, the engine is still spitting out the same codes. The engine’s running much more powerfully now, so it’s like an amplified version of the original problem.

What is the Check Engine light on Acura CL 3.2L?

I’m working with our 2002 Acura CL 3.2L. The engine is running very rough at idle (it sounds like a muscle car). I have two lamps illuminated on the dashboard. The Malfunction Indicator Lamp (MIL) is flashing, and the Traction Control System light is solid. NOTE: Some bulletins refer to the MIL as the Check Engine Light (CEL) as well.

Why is exhaust gas clogging on my Acura?

Purely running off of the feedback of the lamps, I did some online research and found this to be common issue with Exhaust Gas Recirculation (EGR) System Port Clogging. It didn’t take much to pull the intake manifold cover plate off of the engine and have a look.

Why does my Acura DTC sound like a muscle car?

The rough running of the engine seems restricted to idle. This is when the majority of the extra vibration and “muscle car” sound occurs. When the vehicle is driving at any speed, the rough running doesn’t seem apparent. In fact, it seems to drive like normal.

Why does my Acura ABS light keep coming on?

Common symptoms that you may notice when there is a problem with the Acura ABS: Wheels may lock and slide when braking. Common problems that trigger the ABS light to stay on: To reset the ABS light on an Acura, you first need to read the codes with an ABS scanner.

What to do if your Acura Dashboard Light does not turn on?

Park your ACURA in a safe area where you can work safely. Locate the diagnostic port under the dashboard. Turn on the ignition. All ACURA dashboard lights should turn on but do not start the engine. If your ACURA has START/STOP button, press it twice without pressing on the brake pedal. Allow your OBD-2 scanner to connect to the vehicle.

What are the problems with the Acura transmission?

Typical problems include flaring, slipping, or no shifting to third gear at all. Check engine light (CEL / MIL) and gear D5 may also be flashing. To fix this problem, you will need to overhaul the transmission and replace the 3rd gear clutch. A defective valve body can also cause similar symptoms.

When this happens, your Acura transmission will delay shifting between gears in upshifting and downshifting. To fix this problem often a new torque converter is needed.

What kind of engine does an Acura Integra have?

1.8-liter, 4-cylinder, 16-valve DOHC, 140 hp @ 6300 rpm, 124 lbs-ft-torque @ 5200 rpm 15 inch steel wheels ABS system with 4 wheel-speed sensors and electronic/hydraulic control unit 4-speed automatic transmission (optional)

What should I do if my check engine light is still coming on?

Put the keys in your ignition and turn your ignition on and off consecutively after a second in each step. Once it is done, see if the engine check light is still coming on or not. If the check light is off, you are ready to go, but if it is still coming on, get ready by reading the codes with a scanner instead. Let it Go Off Itself