Should the SRS light be on?

When this light comes on, it indicates that a problem has been detected in the system, and one or more airbags may not inflate in the event of a collision. While it’s possible that all the airbags could work as intended even with an SRS warning light, a failure in the airbags is a significant safety concern.

What would cause airbag light to come on?

The most common cause for the airbag light coming on is that the airbag system is deactivated or turned off. There may be an issue with the crash sensors or other airbag component. Alternatively, the sensor in the passenger seat that determines whether that airbag should be active or not may be faulty.

Where to find diagnostic code for Acura check engine light?

1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the glove compartment. The connector has a removable cover. 2. Turn the ignition on. 3. Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s).

Where is the service check connector on an Acura?

Connect SCS service connector special tool No. 07PAZ-0010100, or equivalent, to service check connector located under passenger’s side of dash. Turn ignition On. MIL will indicate DTC (s) by number of flashes. Connect scan tool to 16-pin data link connector (DLC) located under glove compartment under a removable cover. Turn ignition On.

How to find trouble code on Acura 86-89?

To retrieve trouble codes, turn the ignition key to the “on” position with the engine off. 86-89 models: The ECU will flash many short blinks. The total number of blinks equals the code number. For example, 12 short blinks equals code 12, nine short blinks equals code 9, etc..

Where is the DTC code on an Acura?

1. Connect SCS service connector special tool No. 07PAZ-0010100, or equivalent, to service check connector located under the passenger’s side of dash. 2. Turn the ignition on. 3. MIL will indicate DTC’s by outputting a number of flashes. Remember, these are manufacturer specific codes only.