Is the position of the throttle position sensor adjustable?
Be aware that on some applications, the position of the throttle position sensor is adjustable. In these cases, mark the position of the old sensor and adjust the replacement sensor as closely to the position of the old sensor as possible before tightening the retaining screws.
How to install a throttle sensor in a car?
– Install Throttle Sensor body in the Throttle Chamber. Do not tighten bolts. Leave bolts loose. – Connect Throttle Sensor harness connector. – Start engine and warm up sufficiently. – Measure output voltage of Throttle Sensor using voltmeter. – Adjust by rotating Throttle Sensor body so that the output voltage is 0.45 – 0.55 volts.
How to adjust the throttle position on a Dodge Stealth?
Adjust the Throttle Position Sensor (TPS) on a Mitsubishi 3000GT/GTO and Dodge Stealth. TIP: Use a Feeler Gauge to ensure accurate calibration. Slowly turn the Throttle Position Sensor clockwise until you find the point at which the circuit is no longer complete across terminals #3 and #4.
How does the throttle position sensor work on a Hummer?
The Throttle Position sensor moves with the throttle and sends a voltage signal to the computer indicating throttle angle and speed of movement data. The computer uses this data to measure engine load, adjust timing, fuel delivery, EGR, converter clutch operation and clear flood mode.
– Install Throttle Sensor body in the Throttle Chamber. Do not tighten bolts. Leave bolts loose. – Connect Throttle Sensor harness connector. – Start engine and warm up sufficiently. – Measure output voltage of Throttle Sensor using voltmeter. – Adjust by rotating Throttle Sensor body so that the output voltage is 0.45 – 0.55 volts.
Why do I need to do a throttle body alignment?
This procedure cycles the motorized throttle body through various states (idle, part throttle, WOT) to relearn their positions. Some examples of reasons to perform a TBA: In some vehicles, the car will not run correctly, or may not run at all without performing a TBA after one of the above operations.
The Throttle Position sensor moves with the throttle and sends a voltage signal to the computer indicating throttle angle and speed of movement data. The computer uses this data to measure engine load, adjust timing, fuel delivery, EGR, converter clutch operation and clear flood mode.
Is there a motorized throttle on an Audi?
If there is an ISV, then there is no motorized control of the throttle at all. Typically, ’96-’99 VW/Audi have motorized Cable-throttle, and ’00+ VW/Audi have DBW. Obviously, there are some exceptions. This should be obvious but TDI’s do not have throttle bodies . Battery voltage at least 11.5 V Throttle body part must not be dirty (carbonized).