How to replace wheel hub and bearings on Acura TL?

How to replace wheel hub and bearings on Acura TL?

Remove the 17mm nuts near the cotter pins. Disconnect the ABS sensor by removing the 10mm bolts from the knuckle (#15 and 19 Figure 1). Use the tie rod end puller/separator to remove the upper and lower control arm and tie rod end from the knuckle.

What kind of noise does an Acura TL make?

This article applies to the Acura TL (2004-2008). Worn out wheel hubs and bearings generally make their presence known through various noises. These can include snapping, clicking, popping, knocking or clunking, grinding, and even humming or growling.

How do you remove a wheel hub from a bearing?

You have two options when it comes to removing the hub from the bearing – take it to a local machine shop (the smart option if you don’t have a heavy press) or do it yourself. If you choose to DIY, place the knuckle hub side down on the press, then use a 24mm socket to press the hub out.

Where is the cotter pin on an Acura TL?

Pull the cotter pin from the upper control arm (#17, Figure 1), the lower control arm (#18, Figure 1), and the tie rod end using needle nose pliers. It’s a good idea to mark the tie rod end threads for easier re-installation.

How do you remove ABS sensor from Acura TL?

Disconnect the ABS sensor by removing the 10mm bolts from the knuckle (#15 and 19 Figure 1). Use the tie rod end puller/separator to remove the upper and lower control arm and tie rod end from the knuckle. Lift the ball joint out of the lower control arm and pull the knuckle toward you to remove it from the axle.

How to replace front wheel hub assembly on any car?

1A Auto shows you how to repair, install, fix, change or replace a worn out, vibrating or groaning wheel bearing hub. This video is applicable to any vehicle Hey friends! Do you love helping others as much as you love DIY? We are on a mission to make our content even more accessible!

Remove the 17mm nuts near the cotter pins. Disconnect the ABS sensor by removing the 10mm bolts from the knuckle (#15 and 19 Figure 1). Use the tie rod end puller/separator to remove the upper and lower control arm and tie rod end from the knuckle.

This article applies to the Acura TL (2004-2008). Worn out wheel hubs and bearings generally make their presence known through various noises. These can include snapping, clicking, popping, knocking or clunking, grinding, and even humming or growling.

Disconnect the ABS sensor by removing the 10mm bolts from the knuckle (#15 and 19 Figure 1). Use the tie rod end puller/separator to remove the upper and lower control arm and tie rod end from the knuckle. Lift the ball joint out of the lower control arm and pull the knuckle toward you to remove it from the axle.

You have two options when it comes to removing the hub from the bearing – take it to a local machine shop (the smart option if you don’t have a heavy press) or do it yourself. If you choose to DIY, place the knuckle hub side down on the press, then use a 24mm socket to press the hub out.

What happens if you break a lug nut on a car?

A really tight lug nut can require a huge amount of force to remove, and once you get enough leverage to break the nut, you might accidentally knock the vehicle off the jack. Not only can you do some real damage to your car or truck, but you could also injure yourself.