How to remove the front drive shaft on a Nissan Sentra?

Remove the nut retainer from the wheel hub lock nut. Hold the wheel hub and bearing using Tool (A). Loosen the wheel hub lock nut. Using a piece of wood and a suitable tool, tap on the wheel hub lock nut to disengage the drive shaft from the wheel hub and bearing. Do not place the drive shaft joint at an extreme angle.

How do you remove the cv shaft from a car?

Remove the CV shaft from the hub bearing and steering knuckle assembly completely by hand. Place a pry bar in between the transmission housing and the CV axle bearing, and pry the CV axle free from the transmission gently. This process works only on the driver’s or left side of the vehicle.

How do you remove a front wheel sensor?

Refer to BRC-106, “FRONT WHEEL SENSOR : Removal and Installation”. Remove the cotter pin from the drive shaft. Remove the nut retainer from the wheel hub lock nut. Hold the wheel hub and bearing using Tool (A). Loosen the wheel hub lock nut.

How do you take a half shaft out of a car?

Force the half shaft out of the transmission using the large screwdriver. Place the screwdriver between the transmission and the inner CV joint and with a quick jerk pry the axle out of the transmission. Install the new CV joint and other removed parts in reverse order of removal.

How do you replace a half shaft on a Chevy Impala?

Pull up the parking brake handle on the Impala. Pick up the front end of the car with the jack. Put the jack stands under the Impala. Take off the wheels with the tire iron. Put the drain pan underneath the connection between the halfshaft and the transmission.

Loosen the wheel hub lock nut. Using a piece of wood and a suitable tool, tap on the wheel hub lock nut to disengage the drive shaft from the wheel hub and bearing. Do not place the drive shaft joint at an extreme angle. Also be careful not to overextend slide joint. Do not allow the drive shaft to hang down without support.

How to remove the front wheel sensor on a Nissan Sentra?

1 Remove the wheel sensor bolt. Position the wheel sensor and the wheel sensor harness aside. Refer to BRC-106, “FRONT WHEEL SENSOR : Removal and Installation”. 2 Remove the cotter pin from the drive shaft. 3 Remove the nut retainer from the wheel hub lock nut. 4 Hold the wheel hub and bearing using Tool (A). Loosen the wheel hub lock nut.

How to remove disc brake rotor from Nissan Sentra?

Position the brake caliper aside with wire. Refer to BR-41, “BRAKE CALIPER ASSEMBLY : Removal and Installation”. Do not depress the brake pedal while the brake caliper is removed. Put alignment marks (A) on the disc brake rotor and on the wheel hub and bearing. Remove the disc brake rotor.

What kind of wheels does a Nissan Sentra have?

The GXE (available from 1987 to 2003) had a body colored bumper, aero side mirrors with manual remote control, tachometer as well as standard 13″ 175/70R13 alloy wheels along with air-conditioning, variable intermittent wipers, but no standard cassette deck nor any power windows/locks/mirrors.