How to prepare for a suture removal procedure?

Confirm physician/NP orders, and explain procedure to patient. Explaining the procedure will help prevent anxiety and increase compliance with the procedure. Inform patient that the procedure is not painful but the patent may feel some pulling of the skin during suture removal. 2. Gather appropriate supplies.

What’s the best way to replace an ABS module?

Step 2: Move onto part 3 or part 4. Skip to part 4 if you only need to remove the module and not the solenoid block and motor. If the ABS module, solenoid block, and the motor will be removed as a complete unit, move onto part 3.

How are Steri Strips used for suture removal?

Using the principles of sterile technique, place Steri-Strips on location of every removed suture along incision line. 17. Cut Steri-Strips so that they extend 1.5 to 2 inches on each side of incision. Steri-Strips support wound tension across wound and help to eliminate scarring.

How to remove continuous and blanket stitch sutures?

Place Steri-Strips on remaining areas of each removed suture along incision line. The Steri-Strips will help keep the skin edges together. Checklist 35 outlines the steps to remove continuous and blanket stitch sutures. Disclaimer: Always review and follow your hospital policy regarding this specific skill. Perform hand hygiene.

What’s the best way to replace a stair step?

Use a new, sharp blade on your utility knife. Slice the carpet in a straight, horizontal line underneath the lip of the top step. Make a shallow cut so that you don’t cut into the riser, which is the vertical part of the step. An X-acto knife or a razor may work as a substitute for a utility knife, though a utility knife is the best option.

What do I need to replace concrete steps?

Segmented diamond blades for a circular saw and grinder. Irrigation system tubing, valves, elbows, tee and hose adapter. Don’t forget the GFCI extension cord! Concrete mixing tub, wood float, steel trowel and edger.

What’s the best way to replace a suspension spring?

Move the lower control arm down until the spring is completely loose. Remove the spring from the vehicle. Step 7: Remove the old strut or shock. Since you’re replacing the spring, it’s a good idea to replace the strut or shock at the same time. Although this step is not required, it’s recommended by most manufacturers and ASE certified mechanics.

What should I do if my concrete steps are sinking?

And replacement is the only real fix for steps that are sinking or have deep cracks. But if your steps are level and have only the usual damage that goes a few inches deep, you can save yourself a ton of money and/or labor by patching or recapping them. Patching works well for small, shallow chips and cracks (less than 1/4 in. deep).