How to jack up front end of Dodge Ram?
Jacking Up the Front End 1 Place the jack underneath one side of the frame rail at a time, lift it to the desired height, and then place a jack stand under it. 2 Adjust the height of the jack stand and carefully lower the jack until the frame rail is resting on the jack stand. 3 If needed, repeat these steps on the opposite side.
Where do you place a jack stand on a car?
Place your jack underneath the lift points and raise your vehicle on each side if you need to remove additional jack stands. If you jacked your vehicle completely off the ground, remove both of the jack stands from the front before removing the ones in back.
Where are the Jack points on a car?
In some cars, there are two additional central jack points that are located just behind the front and rear bumpers. The rear jack point usually lifts the whole back part of the car while the front one lifts the front part of the vehicle. When using these points, there is the need for jack stands on the sides for more stability.
What kind of Jack do I need for Dodge Ram?
Recommended Dodge Ram jack points. If you are using a scissor jack, you will need to raise up each side of the rear end using the rear axle since they do not have the weight capacity to lift the differential. If using a floor jack, you can lift the rear by using the differential.
Jacking Up the Front End 1 Place the jack underneath one side of the frame rail at a time, lift it to the desired height, and then place a jack stand under it. 2 Adjust the height of the jack stand and carefully lower the jack until the frame rail is resting on the jack stand. 3 If needed, repeat these steps on the opposite side.
Where is the V-belt on a Dodge Neon?
The belts are stacked one on top of the other, with the serpentine belt on the outside. The belt must be removed to take off the alternator belt or the V-belt. You will notice a lip or notch on the top side of the tension pulley that is located top dead center of the passenger side of the engine block.
How do you put a jack under a frame?
These are the long, metal beams that run the length of the vehicle. Place the jack underneath one side of the frame rail at a time, lift it to the desired height, and then place a jack stand under it. Adjust the height of the jack stand and carefully lower the jack until the frame rail is resting on the jack stand.
Recommended Dodge Ram jack points. If you are using a scissor jack, you will need to raise up each side of the rear end using the rear axle since they do not have the weight capacity to lift the differential. If using a floor jack, you can lift the rear by using the differential.