How to install an aftermarket amplifier in an Acura TL?

Bolt the power wire and fuse holder to the positive battery cable, but make sure that the battery cable is disconnected from the battery first. Figure 4. Inline fuse holder and fuse. Pull up the trunk lining and look for a ground point in the back of the trunk. Take your ground wire and crimp on a ring terminal.

Where are the bolts on an Acura TL?

For the rear seats, remove the bolt hidden in the back of the cushion then pull the two tabs at the bottom to release the seat cushion. There are two bolts at the bottom of the seat and two more hidden under the head rests. Remove the bolts then remove the rear seats.

Where is the fuse on an Acura TL?

Solder a fuse holder to the end of the power wire facing the battery and insert a fuse. Then, crimp a ring terminal to the other end of the fuse holder. Bolt the power wire and fuse holder to the positive battery cable, but make sure that the battery cable is disconnected from the battery first. Figure 4. Inline fuse holder and fuse.

What kind of stereo does an Acura MDX have?

This article applies to the Acura MDX (2000-2006). Most of us are used to the old school, single DIN stereos that don’t offer much room for a touchscreen or video display, but many newer cars offer big touchscreens from the factory, and for good reason.

How do you install an Acura MDX antenna?

Plug the harness into the factory harness and reinstall the antenna wire. Carefully slide the new assembly into the dash and reinstall the screws. Reinstall the trim and push it in gently to secure it back into the retaining clips. Figure 6. Wiring diagram for an aftermarket MDX harness.

What kind of car is the Acura TL?

In the face of increased competition, Acura just kept cranking out great automobiles. The 2004-08 TL, for example, is a comfortable, stylish, sporty sedan that’s sure to make both drivers and passengers happy.

Can a technician install a sub woofer on an Acura?

You can have an audio technician from an aftermarket retailer install your sub-woofer, or you can do it yourself for a fraction of the cost. Remove the grounding cable from the Acura’s battery.

Do you need an amplifier for a powered subwoofer?

Powered subwoofers include all the elements of a subwoofer system — subwoofer, amplifier, and enclosure — in one convenient package. Here’s a look at how you install a typical powered subwoofer. Please note: As with any amplifier installation, you’ll also need an amplifier wiring kit.

Where does the power supply go in a TL?

Connect the power supply wiring to the ring terminal. Drill an opening in the firewall to the inside of the TL’s cabin. Place a rubber grommet in the new opening to protect the wiring. Route the power supply cable from the front of the vehicle to the trunk.

You can have an audio technician from an aftermarket retailer install your sub-woofer, or you can do it yourself for a fraction of the cost. Remove the grounding cable from the Acura’s battery.

How do you connect an aftermarket amplifier to a speaker?

Connect the speaker wires to the amplifier and the ground wire to the amplifier. Then, finally, connect the power wire to the amplifier. When you’re ready to test and configure the amplifier, reconnect the battery cables. Figure 9. Install and connect the aftermarket amplifier.

How do you connect a power supply cable to a sub woofer?

Connect the patch cables, power supply cable and turn-on lead to the powered sub-woofer in the trunk at the appropriate outlets. Replace the grounding cable clamp around the negative battery lead. Tighten the clamp with a 10 millimeter wrench.