How many miles can a Chevy Cavalier last?

So I would say with good care you should see between 200 000 to 325 000 (MILES not KMS). Best of luck, hopes this helps. 31 people found this helpful.

How do you reset the check engine light on a Chevy Cavalier?

Without turning on your car, turn the key to the right and you will see all of your dash lights come on. Press on the brake 4 times. On the 4th time, hold the brake petal down for 30 seconds and release. This should reset the light.

How do you reset the 2002 Chevy Cavalier?

1ST PUT KEY IN SWITCH 2ND TURN TO ACC LET IT STAY ON OF 11 MINS. TURN IT OFF AND BACK ON TO ACC FOR 11 MINS. TURN IT OFF AND BACK ON TO ACC FOR 11 MINS. IT TAKES ABOUT 33 MINS TO COMPLETE P.S. DO NOT TURN THE CAR ON ALL THE WAY JUST TO THE ACC WHEN TRYING TO RESET .

What does the service light mean on a 2001 Chevy Cavalier?

This light just means to change the oil. You have to reset it each time you change it. To reset it, turn the key on with the engine off and press the gas pedal to the floor 3 times within 5 seconds.

How do you reset the service light on a Chevy Beat?

Vehicles Without VIC

1. Sit inside the driver’s seat of the Chevy and close the driver’s side door.
2. Insert the key into the ignition and then turn it to the accessory power position (also known as key-on/engine-off).
3. Depress the accelerator pedal fully to the floor three times within a five second span.

How far can you drive on 0 miles to empty?

Depends on what you are driving and how fast you are driving. Most of may past and present vehicles could/can go 30 to 50 miles past 0. You can get a good guess by driving to 0 miles and seeing how much less than a full tank you put in. This is often 1/2 to 1 full gallon.

How do you reset the security system on a 2001 Chevy Cavalier?

You may have to do the passlock reset afterward to get it to start back up though. Turn the key to the on position withiut starting and leave it for just over 10 minutes. Do that three times and after the third time it should start whrn you turn the key.

How to reset the computer on Chevrolet cars?

Select “PCM” on the menu and then choose “codes.” Finally, select “clear all codes.” Unplug the computerized scan tool from the port. Turn on the engine and observe the instrument panel to make sure all warning lights have shut off. The computer is now reset. Turn the key in the ignition to the “Key on/Engine off” position.

How many miles before computer completes after reset?

This part of the drive cycle checks the oxygen sensor heater circuits, air pump and EVAP purge system. B. Turn the A/C compressor off and rear window defroster off and accelerate to 55 mph at half throttle. During this step the OBDII system checks for ignition misfire, fuel trim and EVAP canister purge.

Why does my computer keep resetting on my Chevy Silverado?

Ans: You may have confusion about when you should reset the automotive computer of your Chevy Silverado. In a nutshell, if your car’s check engine light keeps coming on after the repairment, it suggests that the trouble code is still in the memory. And, you have to clear this code out of your car’s PC.

How to reset the computer on a 2001 Monte Carlo?

How to Reset the Computer on a 2001 Monte Carlo Put the key into the ignition and turn it to the “on” position, but do not start the engine. Plug the computerized scan tool into the diagnostic port under the dash. You can buy a computerized scan tool from your local auto parts retailer.

How do you reset the computer on a Chevy truck?

Slip the clamp off of the negative battery terminal and wait 15 minutes. Reconnect the cable clamp and secure it to the terminal with a socket wrench. Start the truck and wait for the engine light to shut off. This will indicate that your computer has been reset (and all trouble codes have been cleared).

This part of the drive cycle checks the oxygen sensor heater circuits, air pump and EVAP purge system. B. Turn the A/C compressor off and rear window defroster off and accelerate to 55 mph at half throttle. During this step the OBDII system checks for ignition misfire, fuel trim and EVAP canister purge.

Ans: You may have confusion about when you should reset the automotive computer of your Chevy Silverado. In a nutshell, if your car’s check engine light keeps coming on after the repairment, it suggests that the trouble code is still in the memory. And, you have to clear this code out of your car’s PC.

How many drive cycles to reset computer on car?

This is full should count and trigger as a full drive cycle for your vehicle. When your car running in long time, you should have best battery tender for car to recharge your battery, it’s important things, your car won’t start if battery is dead or low battery. How many drive cycles?