How many hours does it take to change a water pump?

On average, water pump replacement is a 3 hour job. You may pay less if you buy the pump yourself and give it to the mechanic to install, though use caution and make sure to buy the parts from a reputable source.

Can you replace a water pump by yourself?

The location of the water pump in relation to the engine can vary by application. Whether you can replace it yourself depends on how much experience you have. However, a person who easily figures out how to do things can usually replace a water pump that is on the front of the engine, without any mechanical experience.

How much is a water pump for a 2005 Dodge Neon?

The average cost for a Dodge Neon water pump replacement is between $402 and $469. Labor costs are estimated between $255 and $322 while parts are priced at $147.

How far can you drive with a bad water pump?

Depending on the extent of the damage, it is estimated that you can drive a vehicle with a damaged water pump for 5 to 20 miles. However, it will depend on the time of the day and terrain of the road. If it’s early in the morning, then you can even drive for 20 miles.

Where is the water pump on a Dodge Neon?

The water pump is a part of the engine cooling system of an automobile. Operated by one of the accessory drive belts, it is located on the front of the dodge Neon’s engine. To replace it, you have to remove a number of parts that are located around it.

How do you reassemble a neon radiator?

Ensure the gasket is in the same place as the old one, and place the new water pump on top of it. Bolt it in place and reverse the entire process to reassemble your Neon. Put the radiator fluid back into the reservoir, connect the battery leads, lower the vehicle back to the ground and start the engine.

How to replace the gasket on a water pump?

Disconnect the hoses from the water pump and remove the bolts holding it in place. Remove the water pump as well as the gasket The new pump comes with a new gasket. Replace the old water pump with a new one. Ensure the gasket is in the same place as the old one, and place the new water pump on top of it.

How do you remove the serpentine belt on a neon?

Locate the automatic belt tensioner for the Neon and attach a socket and the ratchet to the bolt on the pulley. Rotate it in the direction indicated on your serpentine belt diagram (varies depending on your exact Neon model) to relieve tension and remove the serpentine belt.