How long does it take to remove and replace a water pump?

How long does it take to remove and replace a water pump?

On average, water pump replacement is a 3 hour job. You may pay less if you buy the pump yourself and give it to the mechanic to install, though use caution and make sure to buy the parts from a reputable source.

What is the labor cost to replace a water pump?

The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314.

How much does it cost to replace a water pump?

The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314. Estimate doesn’t include fees and taxes.

Do you need to replace thermostat when replacing water pump?

Most of the time, RRT will recommend replacing the thermostat at the same time as the water pump. In almost every case, the thermostat is located adjacent to the water pump and needs to be removed to access it. This saves you labor as you usually only would need to purchase the part during this job.

Where is the water pump on a Dodge Neon?

The water pump is a part of the engine cooling system of an automobile. Operated by one of the accessory drive belts, it is located on the front of the dodge Neon’s engine. To replace it, you have to remove a number of parts that are located around it.

How do you reassemble a neon radiator?

Ensure the gasket is in the same place as the old one, and place the new water pump on top of it. Bolt it in place and reverse the entire process to reassemble your Neon. Put the radiator fluid back into the reservoir, connect the battery leads, lower the vehicle back to the ground and start the engine.

How to replace the gasket on a water pump?

Disconnect the hoses from the water pump and remove the bolts holding it in place. Remove the water pump as well as the gasket The new pump comes with a new gasket. Replace the old water pump with a new one. Ensure the gasket is in the same place as the old one, and place the new water pump on top of it.

How do you remove the serpentine belt on a neon?

Locate the automatic belt tensioner for the Neon and attach a socket and the ratchet to the bolt on the pulley. Rotate it in the direction indicated on your serpentine belt diagram (varies depending on your exact Neon model) to relieve tension and remove the serpentine belt.

The water pump is a part of the engine cooling system of an automobile. Operated by one of the accessory drive belts, it is located on the front of the dodge Neon’s engine. To replace it, you have to remove a number of parts that are located around it.

Ensure the gasket is in the same place as the old one, and place the new water pump on top of it. Bolt it in place and reverse the entire process to reassemble your Neon. Put the radiator fluid back into the reservoir, connect the battery leads, lower the vehicle back to the ground and start the engine.

Disconnect the hoses from the water pump and remove the bolts holding it in place. Remove the water pump as well as the gasket The new pump comes with a new gasket. Replace the old water pump with a new one. Ensure the gasket is in the same place as the old one, and place the new water pump on top of it.

Locate the automatic belt tensioner for the Neon and attach a socket and the ratchet to the bolt on the pulley. Rotate it in the direction indicated on your serpentine belt diagram (varies depending on your exact Neon model) to relieve tension and remove the serpentine belt.