How do you turn off anti-theft on a Chevy Cobalt?
Under the steering collum there is a rubber boot. Take that boot off and put your finger straight up into the opening. There will be a small switch that you will have to move to the side to release your key.
How do you turn off anti-theft on a 2007 Chevy Cobalt?
The theft deterrent module (TDM)…With a master vehicle key, turn ON the ignition, with the engine OFF.
- Observe the security indicator. After approximately 10 minutes , the telltale will turn OFF.
- Turn OFF the ignition, and wait 5 seconds .
- Repeat steps 1-3 two more times for a total of 3 cycles or 30 minutes .
What is trouble code b3055 on Chevrolet Cruze?
What is B3055 Trouble Code? B3055: No Transponder Modulation or No Transponder Malfunction.And in another article I wrote before: Chevrolet Cruze Can Not Start & Security Light on:B3055 B2955. It shows a real case about a refit cause B3055 trouble code and vehicle can not start. Step 1: Did you perform the Theft Deterrent Diagnostic System Check?
How to solve auto b3055 trouble codeauto repair technician?
1.Attempt to start the vehicle using all of the vehicle’s available keys. 2.Usign a scan tool,observe for any theft deterrent control module (VTD) DTCs. Do any of the available keys start the vehicle? No: Go to Step 9. Step 6: Do all of the available keys cause DTC B3055 to set? No: Go to Step 7. Yes: Go to Step 9.
What does no crank no start code mean?
In some cases, the ignition switch may malfunction resulting in an engine no crank concern with no trouble codes. If voltage is present on this circuit when in the crank position, inspect the circuit for a short to voltage with both ends of the circuit disconnected. If the circuit is not
What is B3055 Trouble Code? B3055: No Transponder Modulation or No Transponder Malfunction.And in another article I wrote before: Chevrolet Cruze Can Not Start & Security Light on:B3055 B2955. It shows a real case about a refit cause B3055 trouble code and vehicle can not start. Step 1: Did you perform the Theft Deterrent Diagnostic System Check?
1.Attempt to start the vehicle using all of the vehicle’s available keys. 2.Usign a scan tool,observe for any theft deterrent control module (VTD) DTCs. Do any of the available keys start the vehicle? No: Go to Step 9. Step 6: Do all of the available keys cause DTC B3055 to set? No: Go to Step 7. Yes: Go to Step 9.
In some cases, the ignition switch may malfunction resulting in an engine no crank concern with no trouble codes. If voltage is present on this circuit when in the crank position, inspect the circuit for a short to voltage with both ends of the circuit disconnected. If the circuit is not