How do you troubleshoot a blower motor relay?

How do you troubleshoot a blower motor relay?

Turn the key to the on position, and check the fuse in the heater or blower motor fuse panel with a test light. Then lightly touch the service port at the top of the fuse on both sides. If the test light illuminates on both sides of the fuse, the fuse is working properly.

How does the blower motor work on a Honda Accord?

Typically it can be activated by pressing and holding different buttons. Testing Honda power transistor (blower motor control module). For example, in the 2009 Honda Accord, the service manual describes the procedure as follows: Turn the ignition to ON.

How can I tell if my blower motor has a problem?

Press and hold the OFF button and within 10 seconds press and release the Window Defogger button five times. The system enters the self-diagnostic mode and at the end of it, if there is a problem, the fault code will be displayed on the display.

Where does the ground go in a Honda blower motor?

The blower motor control module (Honda calls it Power Transistor) supplies the ground. The power transistor has 4 wires: two come from the climate control system control unit, one is the ground, one goes to the negative terminal of the blower motor.

What are the symptoms of a failed blower motor resistor?

Blower motor resistor problems. Problems with a blower motor resistor are common in many cars. The most common symptom of a failed blower motor resistor is when the heater fan only runs at high speed and doesn’t work at low speeds.

Where is the blower control switch on the dashboard?

The blower control switch on the dashboard controls the circuit flow of the blower motor to adjust the voltage from low, to medium, to medium-high, to high. When on high, the circuit bypasses the blower resistor.

What are the symptoms of a bad blower motor relay?

3. Melted relay. Another more serious symptom of a problem with the blower motor relay is a burned or melted relay. Relays are exposed to high current loads and can sometimes get hot when they develop problems.

What causes a fuse to blow on a blower motor?

If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.