How do you tell what year a 4L60E is?
If you have a one-piece case transmission and you’d like to confirm that It is a 4L60E you’ll need to look at the code on the transmission. The year code starts over every decade, but it’s not an issue because they have a two-piece case in the 2000’s. You can now jump down to the year identification guide.
When did the GM 4L60 E transmission come out?
The 4L60-E is the “E”lectronically shift controlled version of the 4L60. The Late 4L60-E was released in 1997 in and fully phased into wide use through GM by 1998 in both RWD car platforms (including the C6 Corvette) and trucks in both 2wd and 4wd configurations.
How much fluid does a GM 4L60E need?
The 4L60E transmission weighs 146 pounds dry, and 162 wet. It requires 8.4 quarts (9.64″ torque converter) or 11.4 quarts (11.81″ torque converter) of transmission fluid, Below is a list of common transmission problems with the GM 4L60E Transmission and possible solutions to repair.
Why is my Trans bad on my 4L60E?
Trans seems noisy when moving in 1st and Reverse, noise goes away instantly if you shift to N or the transmission goes into 3rd gear: Reaction planetary is worn out due to high miles or insufficient lubrication. Not a critical failure, but not a good sign either.
Is the 4L65E transmission a heavy duty truck?
Mega Monster Transmissions Engineered to Dominate, the 4L65E 4WDMega Monster transmission is tough enough to withstand the rigors of even the toughest heavy duty trucks, used for towing/hauling or off-roading. Questions? Call Us 8
What kind of transmission does a 1997 GMC Jimmy have?
Mine is a 1997 Jimmy 4×4. When it is cold outside, the transmission shift hard from 1-2 and takes quite awhile (as well as a low speed) to shift from 2-3-4. The RPM needle shakes violently back and forth thus preventing the vehicle to obtain speed. The vehicle WILL shift eventually, but this make going up a slight hill very slow and time consuming.
The 4L60-E is the “E”lectronically shift controlled version of the 4L60. The Late 4L60-E was released in 1997 in and fully phased into wide use through GM by 1998 in both RWD car platforms (including the C6 Corvette) and trucks in both 2wd and 4wd configurations.
The 4L60E transmission weighs 146 pounds dry, and 162 wet. It requires 8.4 quarts (9.64″ torque converter) or 11.4 quarts (11.81″ torque converter) of transmission fluid, Below is a list of common transmission problems with the GM 4L60E Transmission and possible solutions to repair.
Why is my GMC Jimmy transmission so slow?
When it is cold outside, the transmission shift hard from 1-2 and takes quite awhile (as well as a low speed) to shift from 2-3-4. The RPM needle shakes violently back and forth thus preventing the vehicle to obtain speed. The vehicle WILL shift eventually, but this make going up a slight hill very slow and time consuming.