How do you replace brake pads on a Dodge Ram?

How do you replace brake pads on a Dodge Ram?

Using a 3/8″ Allen (Hex) socket an ratchet or 3/8″ Allen wrench, remove the two socket head bolts securing the brake caliper to the steering knuckle. If planning to replace the brake calipers as well as brake pads, the brake line should be loosend prior to removing the caliper.

Where are the brake shoes on a Dodge Ram?

So, on a drum-brake-equipped truck, replacing the emergency brake is a matter of replacing the rear brake shoes. The emergency brake on a disc-brake-equipped truck works with shoes located inside of the rear brake rotors.

How do you replace the front brake caliper?

With the front brake caliper removed from the steering knuckle (see Step 2), remove the brake line from the caliper using a 3/8″ combination wrench or socket. Figure 8. Brake line removal. Install the the brake line into the new brake caliper.

How do you remove the caliper from a Dodge Ram?

To completely remove the caliper, you will need to loosen the banjo bolt that secures the rubber brake line to the caliper (Figure 7). This will be the only thing keeping it attached to the vehicle at this time. When you loosen this bolt, brake fluid will leak out, so be prepared to catch it with a suitable container.

Are there disc brakes on 2nd generation Dodge Ram?

The rear brakes on the 2nd Generation Ram are of a drum design and are a bit more complex than contemporary disc brakes. Servicing of brake drums can be overwhelming for some, but do no fret as you can disassemble one drum assembly at a time while using the other as a guide.

What should torque be on new brake pads?

Torque to 38 ft/lbs. After installing new pads on the front axle, several pumps of the brake pedal will be required to move the caliper pistons into position and restore proper brake pedal travel.

Using a 3/8″ Allen (Hex) socket an ratchet or 3/8″ Allen wrench, remove the two socket head bolts securing the brake caliper to the steering knuckle. If planning to replace the brake calipers as well as brake pads, the brake line should be loosend prior to removing the caliper.

How do you remove rotors from brake pads?

Once the pads are off, remove the rotor. On many vehicles, you’ll need to remove the caliper mounting bracket in order to remove the rotor. The brake caliper bolts to the brake caliper mounting bracket which bolts to the spindle assembly. To remove the brake rotor, first remove the brake caliper and then remove the brake caliper bracket.

Can a car wrench do a brake rotor replacement?

Wrench also provides online auto repair estimates and allows you approve and schedule work quickly and easily. With mobile service, you get the job done by an experienced Mobile Mechanic while you get on with your day. What Is a Brake Rotor Replacement? Brakes work by using friction between brake pads and rotors to stop the wheels from rotating.

What kind of bolts do you need to change brake pads?

Torx / Allen Set. Often the brake caliper bolts are held in place with Torx or Allen bolts. This depends on what your car has installed; therefore, it is better to verify you know what you need to change your brake pads. You can quickly identify what your car uses by looking at the two bolts on the caliper’s back.