How do you replace a window motor or regulator?

Start by removing the window-to-regulator bolts (have someone hold the glass while you do this). Then remove the glass by tilting it away from the door and lifting it out. Next, remove the regulator bolts or rivets (drill them out and snake the old regulator out through one of the door panel openings.

What tools do I need to replace a window regulator?

Silicone spray works well.

1. PLEASE WEAR SAFETY. GLASSES! Tools required for removal and.
2. installation of window regulator and. motor assembly:
3. • Panel retainer remover. • Magnet.
4. • T-20 Torx socket or driver. • 1/4” socket or driver.
5. • 5/16” or 8mm socket or driver. • Punch.
6. • Small hammer. • Flat-blade screwdriver or plastic pry.

How to remove a window motor and regulator?

Step 7 – Locate and remove the window regulator bolts, now gently allow the regulator to sit inside the door until the motor is removed. (Note: They are connected to each other with cables.) Step 8 – While the regulator is resting inside the door, locate and remove the window motor mounting bolts.

How to install and remove window regulator 741-644?

STEP 1d: Disconnect electrical connections to switch. STEP 1e: Gently pry around door lock bezel and unsnap it from door panel. Unclip from door lock rod and remove. STEP 1f: Using a 7mm socket, remove the 3 highlighted screws. STEP 1g: Lift trim panel up and remove from door. INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR 741-644

How to install a new power window motor?

Installing a New Power Window Motor 1 Slide the new motor and regulator back into place. Insert the power window motor and regulator back into the main service port in the door in exactly the opposite order that you removed them in when disassembling the door.

Where is the regulator on a power window?

Locate and remove the window motor mounting bolts. The power window motor is much smaller than the regulator, but should be located close by. In most applications, the bolts securing the motor to the door are the same size as the regulator mounting bolts. Remove them and set them someplace safe as well.

Step 7 – Locate and remove the window regulator bolts, now gently allow the regulator to sit inside the door until the motor is removed. (Note: They are connected to each other with cables.) Step 8 – While the regulator is resting inside the door, locate and remove the window motor mounting bolts.

Installing a New Power Window Motor 1 Slide the new motor and regulator back into place. Insert the power window motor and regulator back into the main service port in the door in exactly the opposite order that you removed them in when disassembling the door.

Locate and remove the window motor mounting bolts. The power window motor is much smaller than the regulator, but should be located close by. In most applications, the bolts securing the motor to the door are the same size as the regulator mounting bolts. Remove them and set them someplace safe as well.

How do you replace the power window on a Camaro?

Remove the two screws located underneath the arm rest and the one located down in the door pocket. Remove the Phillips screw just below the door handle. Remove the screw from the side mirror and pull the cover off. Pull up and out on the door panel to remove it. Disconnect the connector that goes to the speaker and set the panel aside. Figure 1.