How do you remove the top end of a Harley Davidson?

How do you remove the top end of a Harley Davidson?

Label the cylinders and set aside. Now you can push clean shop towels into the openings of the crank case to protect against anything falling into your lower end, while the top end is apart. Finally, you can remove your pistons from the connecting rods. It is important to slide short lengths of rubber hose over your cylinder studs for protection.

How do you remove head gaskets on a Harley Davidson?

You are now stripped down to the heads. You will need a 1/2″ 12 point socket to loosen your head bolts. Break them free with one sharp motion; then continue to loosen evenly in a cross pattern. Lift off your heads and remove the old head gaskets.

What do you need to know before you pull that head off?

You can test with light, liquid, air, or a combination. Note that, for all of these, the valves need to be in the closed position, so you either need to remove the camshaft and the valve train, in which case all of the valves are closed at the same time, or you need to rotate the cam to close the valve you’re testing.

How do I cap off / remove a single sprinkler head?

It depends on where the sprinkler head is located within that zone. If the sprinkler head that you are capping is not a dead end on the line, then you can cap it at this sprinkler head. If it is a dead end, then you need to go to the prior sprinkler head to cap the line.

Label the cylinders and set aside. Now you can push clean shop towels into the openings of the crank case to protect against anything falling into your lower end, while the top end is apart. Finally, you can remove your pistons from the connecting rods. It is important to slide short lengths of rubber hose over your cylinder studs for protection.

How do you remove cylinder head on Honda Foreman?

Now its Time To remove the cylinder head start by gently taping the cylinder head with a hammer to loosen the seal ( Do not strike the cylinder head too hard) once it is loosened it will come right off (straight up).Now it will look like this. next you need to remove the two dowel pins and gasket (just pulls off) .

What to remove from Honda Top End rebuild?

Now Remove the following spark plug cap,sparkplug , rocker arm bolt the four cap nuts and washers (Loosen in a crisscross patter in 2 or 3 steps) and the two 6mm bolts. then remove the rocker arm.

You are now stripped down to the heads. You will need a 1/2″ 12 point socket to loosen your head bolts. Break them free with one sharp motion; then continue to loosen evenly in a cross pattern. Lift off your heads and remove the old head gaskets.