How do you refill the coolant?

If your engine is cold, the coolant level should be up to the cold fill line. Loosen the reservoir cap just a little, then step back while the pressure releases. Then, remove the cap completely. If the coolant level is low, add the correct coolant to the reservoir (not the radiator itself).

What kind of coolant does a Saturn sl2 take?

Antifreeze/Coolant Prestone 1 Gallon Yellow 50/50 Coolant/Antifreeze.

Can you mix old and new coolant?

If you mix up different types of coolants (propylene glycol \ ethylene glycol) you might end up having gel like substance which naturally will fully or partially block coolant flow, causing eventual engine failure (over heating).

How do you get coolant out of a Saturn SL1?

Top off the overflow reservoir to the full line. Run the SL1 with the radiator cap off to allow the air to bleed from the radiator. As the Saturn heats up to running temperature, it will suck in coolant, requiring more to be added as it purges air pockets from the radiator, spilling some of the coolant in the process.

What kind of coolant do you use in a Saturn?

Place a funnel into the radiator neck and fill the radiator with global coolant that is premixed or broken down with equal parts coolant and water. Saturns call for Dex-cool, which is fine, but global coolant has been created to work in virtually any vehicle.

How do you change the radiator cap on a Saturn?

Place the drain bucket below the radiator neck to catch the spillage. Add more coolant as necessary. Once the temperature gauge on the dash indicates 190 degrees F–or normal–replace the radiator cap and allow the Saturn to run for another 15 minutes.

How to fill the transmission fluid on a 2000 Saturn SL?

How to Fill the Transmission Fluid on a 2000 Saturn SL. Unlike some cars, Saturn models are designed to have transmission fluid poured through the dipstick opening. The transmission dipstick has a yellow handle and is located between the battery and oil dipstick that is red. The opening is small, so you’ll need a funnel with a very slim spout.

How do you get coolant out of a Saturn radiator?

Remove the jack. Grab the pliers and the drain bucket and crawl under the front of the Saturn. Locate the petcock valve of the radiator along the bottom rail of the radiator. Position the drain bucket beneath the petcock valve and turn the valve counterclockwise to open. Use pliers, if necessary. Coolant will begin trickling immediately.

Why is the radiator cap off on Saturn SL1?

Run the SL1 with the radiator cap off to allow the air to bleed from the radiator. As the Saturn heats up to running temperature, it will suck in coolant, requiring more to be added as it purges air pockets from the radiator, spilling some of the coolant in the process.

How often should I change the coolant in my Saturn SL1?

Changing the coolant in your Saturn SL1 is part of the scheduled maintenance routine. Depending on how much you drive the car, the SL1 should have the coolant replaced every two to three years for optimal performance.

Where is the petcock valve on a Saturn radiator?

Grab the pliers and the drain bucket and crawl under the front of the Saturn. Locate the petcock valve of the radiator along the bottom rail of the radiator. Position the drain bucket beneath the petcock valve and turn the valve counterclockwise to open. Use pliers, if necessary. Coolant will begin trickling immediately.