How do you change the oil on a 2013 Dodge Avenger?

Depress the Accelerator (“Gas”) pedal down 3 times within 10 seconds. 3. Turn off the ignition switch. The “Change Oil” warning light should not be displayed the next time you start the engine.

How do you reset the change oil light on a Dodge Avenger?

To reset the oil change service light indicator system for a Dodge Avenger (after performing the scheduled maintenance) perform the following procedure.

1. Turn the ignition switch to the ON position.
2. Fully depress the accelerator pedal slowly 3 times within 10 seconds.
3. Turn the ignition switch to the LOCK position.

How do you change the oil on a 2008 Dodge Avenger?

How do you change the oil on a 2008 Dodge Avenger?

1. Getting Started.
2. Open the Hood.
3. Find Oil Drain. Locate the oil drain plug underneath the vehicle.
4. Drain Oil. Set up the workspace, drain oil and replace plug.
5. Find Oil Filter. Locate the oil filter.
6. Remove Filter.
7. Replace Filter.
8. Remove Oil Cap.

How much oil does a Dodge Avenger?

Engine Oil 4.5 quarts. . .

How much oil does a 2013 Dodge Avenger hold?

The 2013 Dodge Avenger’s 2.4 liter 4Cylinder engine is equipped with 4.5 US quarts of 5W-20 with a filter.

How much oil does a 2013 Dodge Avenger v6 take?

5.9 quarts (with filter)After refill check oil level.

What kind of oil filter for 2008 Dodge Avenger?

Dodge Avenger SE / SXT 2.4L 2008, Extended Performance Oil Filter by Mobil 1®. Mobil 1 Extended Performance Oil Filters offer the ultimate protection for your engine, especially when used with Mobil 1 full synthetic motor oil.

What kind of oil does my 2008 Dodge Avenger take?

Dodge Avenger 2008, SAE 5W-20 Synthetic Motor Oil, 1 Quart by Eneos®.

What type of oil do you put in a Dodge Avenger?

Castrol Edge Synthetic Motor Oil 5W-20 1 Quart.

What kind of oil does a Dodge Avenger 2014 take?

Dodge Avenger 2014, Professional Series SAE 5W-20 Full Synthetic Motor Oil, by Red Line®.

How do you reset the oil change light on a Dodge Avenger?

You can clear and reset the light with these steps. Turn the ignition to “ On ” where the electronics are on, but the engine is off. Gently press the gas pedal all the way down three times within a ten second interval. Turn the ignition to “ Lock “. The next time you start the Avenger, the Oil Change light should be off.

How do you change the oil on a Dodge?

Step 1: Insert key into the ignition and turn key to “ON” without starting the engine. Step 2: Slowly depress the accelerator pedal three times in succession in under ten seconds. Step 3: The system should be reset.

When to reset the Dodge oil change indicator?

When your vehicle is ready for an oil change, Dodge has a recommended list of scheduled maintenance items that coincide with the mileage accrued: After your oil change and servicing is complete, you might need to reset the Oil Change Indicator system in your Dodge. Learn how to do this by following the directions below:

When do you know it’s time for an oil change?

Once the information display number reduces from 100% (fresh oil) to 15% (dirty oil), an “OIL CHANGE DUE” light will be trigged on the dashboard information display, giving you ample time to plan ahead to have your vehicle serviced. Every time you start the engine, the engine oil percentage will be displayed.