How do you change automatic transmission on Acura TSX?

How do you change automatic transmission on Acura TSX?

Your Acura has an automatic transmission dipstick, which, for our purposes, also doubles as a place to fill the transmission. Pull out the dipstick, line up your funnel and pour in your ATF. Start with about two liters worth of fluid, check the level and keep filling as necessary.

How much fluid does an Acura TSX take?

Start with about two liters worth of fluid, check the level and keep filling as necessary. Depending on how much you were able to drain, this should end up around 3-4L of fluid. Figure 6. Use the transmission dipstick as a means of filling and then checking the fluid level.

How often should I Change my Acura transmission?

Honda/Acuras advises to do this once every two years or 30,000 miles, so if your ride is due, let’s get it done. To get started, we need to jack the front end of the car up for access. Use the front jack point on the crossmember and then set stands on either side of the car on the reinforced part of the pinch welds.

What kind of transmission does an Acura TSX have?

This only applies to the automatic transmission, as the manual transmission is mechanical, and does not have the same reliance on electrical controllers like the auto. That said, the most common electrical-related issues with the TSX’s automatic transmission are related to shift solenoids.

What does the flywheel do on an Acura TSX?

However, if we expand upon that, it gets a bit more complicated: as engine spins (RPM), it’s spinning the flywheel, which couples with either the clutch in a manual transmission, or the torque converter in an automatic transmission.

What is the diagnostic code for an Acura TSX?

These solenoids can fail and they will cause diagnostic trouble codes to appear on your dash. Use a OBD-II trouble code reader and retrieve any error codes stored in the car’s computer. If you do not have a code reader, most auto parts stores have this tool. Common transmission fault codes are P0974 and P0986.

What does slipping mean in an Acura TSX?

Slipping refers to the engine RPMs shooting up, and the car not accelerating. This happens in a few instances: A damaged torque converter in your automatic transmission. If it’s not the torque converter, your transmission may have an internal defect or damage.

However, if we expand upon that, it gets a bit more complicated: as engine spins (RPM), it’s spinning the flywheel, which couples with either the clutch in a manual transmission, or the torque converter in an automatic transmission.

Slipping refers to the engine RPMs shooting up, and the car not accelerating. This happens in a few instances: A damaged torque converter in your automatic transmission. If it’s not the torque converter, your transmission may have an internal defect or damage.

Your Acura has an automatic transmission dipstick, which, for our purposes, also doubles as a place to fill the transmission. Pull out the dipstick, line up your funnel and pour in your ATF. Start with about two liters worth of fluid, check the level and keep filling as necessary.

Start with about two liters worth of fluid, check the level and keep filling as necessary. Depending on how much you were able to drain, this should end up around 3-4L of fluid. Figure 6. Use the transmission dipstick as a means of filling and then checking the fluid level.