Recommendations

How do you change a license plate light on a Chevy Cavalier?

writer 0 comment

How do you change a license plate light on a Chevy Cavalier?

Anonymous

  1. Open the hatch and stand under it.
  2. Remove pull handle from the inside of the hatch (2 screws under pop panels).
  3. Starting in the lower corners, gently pry the entire interior panel from the hatch,
  4. Grasp the bulb housing and twist to the left while pressing inward.
  5. Replace with a 1156 bulb.

Why does my license plate light keep going out?

This could either be a problem with a relay switch, a loose connection or the license plate light has burnt out and needs to be replaced. Most license plate lightbulbs are the same, but you should always check with an auto parts store or contact a professional mechanic to replace the lightbulb with the right one.

How do you replace the light bulb on a license plate?

Remove the license plate light cover retaining screws using a screwdriver. Remove the license plate light cover. Note: You may need to use a small screwdriver to pry the cover off. Step 4: Remove the bulb. Remove the bulb from its retainer. Step 1: Install the new bulb.

How do I install a new light bulb on my car?

Install the new bulb in its retainer and ensure it is in place. Tip: Refer to your car’s user manual to determine the correct type of light bulb to get for your specific vehicle. Step 2: Complete the installation. Put back the license plate light cover and hold it in place.

What to do if your license plate light has failed?

The license plate light is located right above the plate. Step 2: Determine which bulb has failed. Park your vehicle and set the emergency brake. Turn the ignition to the Accessory position and turn on the driving lights. Walk around the vehicle to determine which license plate bulb has failed. Step 3: Remove the license plate light cover.

Where is the light on the license plate?

Step 1: Locate the license plate light. The license plate light is located right above the plate. Step 2: Determine which bulb has failed. Park your vehicle and set the emergency brake. Turn the ignition to the Accessory position and turn on the driving lights.