How do I fix error code P0342?

What repairs can fix the P0342 code?

1. Recharging or replacing the battery.
2. Repairing or replacing the starter motor.
3. Repairing or replacing any faulty wiring or connectors.
4. Replacing a defective camshaft position sensor.

What does a faulty crank angle sensor do?

If the crankshaft position sensor or its wiring have any issues, it can cause the crankshaft signal to be cut off while the engine is running, which can cause the engine to stall. This is usually a symptom of a wiring problem, however a bad crankshaft position sensor can also produce this symptom.

What does code po452 mean?

When the Engine Control Module (ECM) purges the stored fuel vapors the pressure goes down. When code P0452 is triggered the ECM has detected an abnormally low voltage for an extended period of time. This can be caused by a faulty sensor, wiring or an EVAP system leak.

Can I drive with a P0341 code?

Trouble code P0341 should be diagnosed and repaired as soon as possible. Not recommended, however, you may drive your vehicle while trouble code P0341 is present unless the engine stall or stumbling is is severe enough to hinder proper vehicle operation. Erratic engine speed may be noticed.

What does the p0341 on a Chevy mean?

P0341 CHEVROLET Meaning The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module (ECM) to control ignition and fuel injection.

When is the camshaft position sensor code p0342?

All our repairs are backed by our 12-month / 12,000-mile warranty. The PCM (powertrain control module) sets code P0342 when it detects that the camshaft position sensor circuit on engine bank 1 is sending a reading that’s erratic or otherwise outside the manufacturer’s settings.

What does p0342 mean on a bank 1 sensor?

In this instance, code P0342 infers the sensor’s signal is to low, or not strong enough. The signal is low enough to be vague and difficult to interpret. P0342 refers to the Bank 1 “A” sensor. Bank 1 is the side of the engine that contains cylinder #1. It’s important in today’s vehicles to understand what these sensors are and how they interact.

Are there any DTCs associated with p0342?

DTC P0342 or P0347 may be accompanied by other DTCs, such as P0300 Random Misfire, P0725 Engine Speed Sensor Circuit, or P0335 Crankshaft Position Sensor Circuit Malfunction. None found. Ask a question about P0342 .

What causes a p0342 Chevy camshaft position sensor circuit low voltage?

Sometimes and in some models, low battery voltage or a weak starter can trigger a Camshaft Position Sensor code. The cost of diagnosing the P0342 CHEVROLET code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.

P0341 CHEVROLET Meaning The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module (ECM) to control ignition and fuel injection.

What causes a p0342 OBD-2 trouble code?

There are a number of issues that can trigger a P0342 code. These include: A weak or dead battery. An open or shorted camshaft position sensor wiring harness. A defective starter motor. A problem in the starting system circuit. A defective camshaft position sensor.

When does the PCM set the code p0342?

The PCM (powertrain control module) sets code P0342 when it detects that the camshaft position sensor circuit on engine bank 1 is sending a reading that’s erratic or otherwise outside the manufacturer’s settings. The PCM then illuminates the Check Engine light to alert the driver of the problem.