How do I change a water pump?

How do I change a water pump?

Loosen the bolts and remove the old water pump. Remove the old seal/gasket or old sealant remains and make sure the mounting surface is clean. Before installing the new water pump, inspect the other cooling system service parts: coolant hoses, thermostat and pressure cap(s). Install the new water pump.

Is it easy to replace a water pump?

While removing the pump is not difficult, you must have experience removing and replacing timing belts and their various components. It takes just as much work to get down to the timing belt as it does the water pump, therefore you should plan on replacing the belt at the same time.

How long does it take to change a water pump and timing belt?

1-3 hours
Changing a timing belt and water pump can take anywhere from 1-3 hours depending on your skill level, so make sure you have the time and space to complete the job.

Where is the water pump on a Dodge Neon?

The water pump is a part of the engine cooling system of an automobile. Operated by one of the accessory drive belts, it is located on the front of the dodge Neon’s engine. To replace it, you have to remove a number of parts that are located around it.

How do you reassemble a neon radiator?

Ensure the gasket is in the same place as the old one, and place the new water pump on top of it. Bolt it in place and reverse the entire process to reassemble your Neon. Put the radiator fluid back into the reservoir, connect the battery leads, lower the vehicle back to the ground and start the engine.

How to replace the gasket on a water pump?

Disconnect the hoses from the water pump and remove the bolts holding it in place. Remove the water pump as well as the gasket The new pump comes with a new gasket. Replace the old water pump with a new one. Ensure the gasket is in the same place as the old one, and place the new water pump on top of it.

How do you remove the serpentine belt on a neon?

Locate the automatic belt tensioner for the Neon and attach a socket and the ratchet to the bolt on the pulley. Rotate it in the direction indicated on your serpentine belt diagram (varies depending on your exact Neon model) to relieve tension and remove the serpentine belt.