Does it matter which way rear shocks go?

Does it matter which way rear shocks go?

Bilstein tech advises that you should always mount your shocks so that the Bilstein logo is right-side up. Above is Bilstein rear shock 24-186742 for the 1999-2010 Chevy Silverado and GMC Sierra. The shock has 14.1 mm mounting eyes on each end. If it is upside down, so are your shocks!

Can rear shocks be installed upside down?

No. With the exception of a few specialty shocks, you should never mount your shock absorbers upside down. Typical twin-tube shocks are simply not designed to function upside down for many important reasons.

Do shocks have a top and bottom?

The upper mount of the shock absorber connects to the vehicle frame. This upper mount is called the piston rod, and at the bottom is the piston.

Why do I need to replace my rear shock absorber?

Rear shock absorber. This is because a new shock absorber will absorb road bumps better than the old one. If you replace only one shock absorber, it may create “unevenness” from side to side when driving over bumps.

How to replace your own shocks and struts?

How to replace shocks and struts 1. Check whether you need a spring compressor. On many cars, the struts/shocks and springs are interrelated or… 2. Securely raise one side of the car. If you’ve got access to an actual lift, great. Driveway DIYers everywhere are… 3. Remove the wheel and extract …

How often should I replace my shocks on my car?

Signs that your shocks may need attention include: Struts are wear items that absorb countless bumps in the road, which is why replacing struts on a car is recommended every 50,000 miles. What’s the difference between shocks and struts? The words “shocks” and “struts” are often used interchangeably, but they aren’t the same thing.

Where are the shocks located on a car?

The top bolts for the front shocks are typically accessed under the hood. Rear shocks can be accessed from under the vehicle on some vehicles. With others, the top mounts are sometimes accessed from inside the vehicle in areas such as the rear parcel shelf or in the trunk. Verify your shock mounting locations before starting.

What’s the best way to replace a rear shock?

Use penetrating oil if needed to loosen the bolts and nut. Use a socket wrench and 10mm socket to remove the splash guard bolt, and splash guard. Then, remove the bottom nut using a socket. Next, remove the top bolt (s) with your socket.

The top bolts for the front shocks are typically accessed under the hood. Rear shocks can be accessed from under the vehicle on some vehicles. With others, the top mounts are sometimes accessed from inside the vehicle in areas such as the rear parcel shelf or in the trunk. Verify your shock mounting locations before starting.

Do you need an alignment after replacing shocks and struts?

On some vehicles, the installation of new shocks and struts may affect your car’s wheel alignment. However, there are some instances where alignment is not required after replacing the struts or shocks.

How do you install shocks on a Harley Davidson?

Raise the wheel (easier with a helper) to align the hole and install the lower shock mounting bolt. Install the other shock in the same way, remembering to clean and put a drop of blue Loctite on each mounting bolt. Tighten all four mounting bolts to 35 to 40 foot-pounds.