Can you disable anti-theft system?

In order to deactivate the anti-theft system, car owners must press the unlock button located on the remote key. So it is suggested to use the key to unlock the door, then change the switch of ignition to “on” position.

How to disable the theft system on a Chevy Cavalier?

Just leave the key in the run position and the “Theft System ” light on the dash will be flashing. Leave the key on for about 10 minutes and the light will stop flashing and go on solid. Then the theft system is disable.

How to over ride anti-theft so car will start?

When does the security light come on on a Chevy Cavalier?

The security light usually comes on with all the the lights and just like all the lights it will go off within 10 seconds as long as no error is seen.

Is there a recall on the Chevy Cavalier?

Thinking they should recall something that starts to fail when it gets old is just stupid. that’s like saying they should recall every vehicle for old ball joints going bad, it’s not a defect it’s called old and worn.

How to disable the anti theft device in your car?

Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder. Tip: Try turning the key both ways fully to disable the anti-theft system.

What happens if I dont turn on my anti theft system?

The key you are using may not have the chip required to start your car. If the anti-theft system has locked up your engine, you won’t be able to start it. You’ll have to disable it with these steps. Step 1: Check for the anti-theft light. It’s located on your dash and will have a blue or red light. Step 2: Turn the ignition to the “on” position.

How to disable the PassLock sensor on a Chevrolet Cavalier?

Under the ignition cylinder there is a small connector. Unplug it. This is your passlock sensor. Key on 3 times for 11 minutes each. You may need a battery charger. At the end of the 3rd ignition cycle if the PCM doesnt see the passlock sensor “because you unplugged it” it will disable the passlock.