Can low coolant cause P0117?

Can low coolant cause P0117?

There are a lot of issues that could trigger the engine code P0117. Below are just some of the possible causes of P0117: Defective engine coolant temp sensor. Damaged or corroded engine coolant temp wiring or connection.

How do you fix a temperature sensor?

Let’s Get Started

  1. Release the Cooling System Pressure. Locate and slowly remove the cooling system pressure cap to relieve the system of any residual pressure.
  2. Locate the Coolant Sensor.
  3. Remove the Electrical Connector.
  4. Remove the Coolant Sensor.
  5. Install the New Coolant Temperature Sensor.
  6. Refill the Cooling System.

What causes a P0117 code?

Error Code P0117 is described as Engine Coolant Temperature (ECT) Sensor Circuit Low Input. Meaning, the PCM (powertrain control module, also referred as ECM or engine control module) determined the ECT sensor output going less than 0.14V or above 284˚ F (140˚ C).

Where is the temperature gauge sensor located?

Usually, the location of the coolant temperature sensor will be located directly behind the coolant pipe. In most modern cars and vehicles, this is present behind the right cylinder head that is located right underneath of the air intake pipe.

How to diagnose a check engine code p0117?

How To Diagnose Code P0117 1 Check to see if there are any other codes along with P0117 and clear your Check Engine Light with FIXD. 2 Disconnect the ECT sensor and check the circuit wiring for fraying or a poor connection. 3 Check the cooling system for air pockets or dirty/rusty coolant.

How much does it cost to repair a p0117 Dodge engine?

The cost of diagnosing the P0117 DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P0117 DODGE code detected? An excessively low voltage from the sensor is sent to ECM.

What does p0171 mean on Dodge fuel system?

P0171 DODGE Tech Notes If the P0171 is combined with the P0174 code, it’s very likely that the problem is caused by an intake leak. If there are no intake leaks, the next step is to replace the air filter and clean the air flow meter. If the problem persists the front oxygen (O2) sensor may need to be replaced. What does this mean?

What should I do if I have a p0171 code?

If the P0171 is combined with the P0174 code, it’s very likely that the problem is caused by an intake leak. If there are no intake leaks, the next step is to replace the air filter and clean the air flow meter. If the problem persists the front oxygen (O2) sensor may need to be replaced. What does this mean? Cost of diagnosing the P0171 DODGE code