Can a throttle body make a car not start?

The only way a TPS will cause a no – start is if the TPS is busted/stuck, and the TPS is telling the computer that you’ve floored the gas. The computer won’t pulse the injectors, because when you floor the gas (WideOpenThrottle) and crank the engine, the computer goes into “clear flood mode”.

Can a bad crank cap cause a no start?

The ignition control module could be bad. The crankshaft position sensor could be bad. Testing the distributor cap, the ignition coil to distributor cap high tension wire, the ignition coil, the ICM, and the crank sensor can by done by the do it yourself-er (DIY’er) and the following tutorials will help you test the ignition system:

Why does my Car Crank but not get fuel?

IT WILL NOT GET FUEL IN THEFT MODE , WHICH IS WHY YOH GET THE CRANK BUT NO START!!! unfortunately your car either forgot the key , or the key itself took some damage either way just have it relearn the key , put it in the on position , and leave it for 15 mins or so or get a new key and have it programmed , YW Was this answer helpful?

How to troubleshoot a GM 4.3L no start?

Check that the 8 cylinders are getting spark with a spark tester. The distributor cap is good. The ignition coil is good. The ignition control module is good. The crankshaft position sensor is good. The distributor cap could be bad. The ignition coil to distributor cap high tension wire could be bad. The ignition coil could be bad.

How to test the no start ignition system?

Testing the distributor cap, the ignition coil to distributor cap high tension wire, the ignition coil, the ICM, and the crank sensor can by done by the do it yourself-er (DIY’er) and the following tutorials will help you test the ignition system: How To Test A Misfire / No Spark No Start Condition (at: easyautodiagnostics.com ).

What causes a bad throttle body cause your car to not start?

The only way a TPS will cause a no-start is if the TPS is busted/stuck, and the TPS is telling the computer that you’ve floored the gas. The computer won’t pulse the injectors, because when you floor the gas (WideOpenThrottle) and crank the engine, the computer goes into “clear flood mode”. What causes a bad throttle body?

How to reset throttle body calibration [ step by step guide ]?

Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.

Why does my car not start when I Turn on the ignition?

The most common causes are in the ignition (for example, a bad ignition coil) or fuel system (for example, a clogged fuel filter). However, the source may also be a mechanical fault (for example, a leaking valve), or faulty components in other systems.

Why does my fuel pump not turn on?

Well getting to start by adding fuel to the throttle body is not going to turn on some special switch that will send a signal to the pump and injectors. I’m sure you probably just have a bad fuel pump that doesn’t have enough pressure or volume to start the truck, but at running speed can keep up.