Can a bad ECM cause high idle?

Can a bad ECM cause high idle?

If the computerized engine control system is faulty, high idling can be one symptom. A vacuum leak in any of the hoses can be the culprit—inspect them all for leaks. A bad idle-speed control unit can cause the problem; it may need to be replaced. A faulty alternator can fast idle issues; if so, replace it.

What causes an Impala to stall before starting?

When the system voltage gets below ~9v, the ECM and ignition system can no longer function correctly, which causes the engine to stall. * A complete charging system test should be performed before replacing the alternator.

What to do when your car is at high idle?

While observing the valve with a flashlight, turn the key to the “ON” position, (DO NOT START ENGINE.) the valve should move slightly. Step 3 – Engine vacuum is a sealed system and must hold a specific amount to maintain proper idle conditions, inspect the engine vacuum hoses and intake gaskets.

When did my Impala run out of gas?

The car was running perfect…i havent driven it since October while working on the interior …when i parked it there was around 1/8th of a tank of gas…Ive started the car one a week since …..last week i pulled the car out and let the car run to charge up the battery….well it ran out of gas….

Why does my car idle at a higher RPM than normal?

Updated January 19, 2019. If your car seems to be revved up to a higher-than-normal RPM while idling, it’s not necessarily a problem. If this problem happens while the engine is cold, it may be part of the engine’s design.

Can a bad idle control valve cause stalling?

This is controlled by the engine’s computer. Sometimes parts go bad, which results in your car idling strangely or stalling. Check to see if your idle control valve is functioning properly before attempting to replace it. Look for a high engine idle. A common symptom of a faulty idle control valve can be a high idle.

Why is my idle control not working on my car?

If the idle has not changed at all, it’s likely because your idle control motor has not been functioning. If the idle control motor was working, disconnecting it should have created a difference in the engine’s idle. This test confirms there’s an issue with the idle control motor, but not what the issue may be.

How can you tell if an idle air control valve is working?

Disconnect the IAC connector for a couple seconds while your engine is idling. If your engine idle didn’t change, you can suspect it to be the IAC. If it is working properly, unplugging it would cause your idle to freak out. Also check the wires going to the IAC connector.

Why is the idle on my air conditioner so low?

If the idle is low and inconsistent, it may be due to an issue with your idle control valve. Low idles could also be caused by vacuum leaks. 3 Look for signs of a vacuum leak.