How do you jack up a Chevy truck?
How do you jack up a Chevy truck?
Park the Chevy truck on a flat surface and engage the parking brake. Loosen the lug nuts from the rear wheels counter-clockwise with a tire tool. Jack the rear end of the Chevy truck up and place the jack stands under the proper rear jacking points.
What was the factory manual for a 1937 Chevy truck?
1937 Chevrolet Car and Truck Factory Shop Manual Covering the following Chevy Models: GC 1/2 Ton Truck, GD 3/4 Ton Truck, GE 1 Ton Truck, 1 1/2 Ton Truck, Master, Master Deluxe, Sedan Delivery, Truck Complete Volume | General Motors…
How do you replace the ignition switch on a Chevy truck?
The ignition switch shares a mounting screw with the dimmer switch. Remove two additional mounting screws holding the ignition switch in place. Gently pry out the switch rod that runs the length of the column to the key and tumbler.
What is the shop manual for a Chevy?
…written by General Motors specifically for the year and vehicle (s) listed. Official Shop Manuals that the dealers and shop technicians use to diagnose, service and repair your Chevy Pick-Up Truck, Astro Van, Blazer, Camaro, Colorado, Corvette, Cruze, Equinox, Express Van, S10, Silverado, Suburban, Tahoe, or Volt vehicles.
How big is a 1941 Chevy truck panel?
1941 1T AN – (Commercial – 1 Ton – Wheelbase 134 1/2in.) 1941 1.5 YR – (Utility – 1 1/2 Ton – Single Or Dual Wheels – Wheelbase 134 1/2in.) 1941 1.5 YR Panel – (Utility – 1 1/2 Ton – Single Or Dual Wheels – Wheelbase 134 1/2in.) 1941 1.5 YS – (Utility – 1 1/2 Ton – Single Or Dual Wheels – Wheelbase 160in.)
Where can I find 1941 Chevy truck parts?
1941 Chevy Truck Parts | Chevs of the 40s has the most complete inventory of 1941 Chevy Truck restoration parts and 1941 Chevy Truck street rod parts. We offer a full line of 1941 Classic Chevy Truck parts for your project car.
How do you replace a pinion seal on a Chevy truck?
Slide the pinion yoke off the pinion shaft and set it aside. Using a small flat screwdriver, bend the outer metal ring of the seal to help loosen it then pry it out of the bore. Pack the cavity behind the seal with lithium grease then install the new seal into the bore.
What was the difference in a Chevy truck in 1941?
The 1941 Chevrolet trucks entire front end was all new. The larger, more impressive truck had an increased wheelbase and more power. Chevy discontinued the stamped name in the tailgate that year. The longer wheelbase enabled the cab area with additional legroom and the seat back was reclined to a more comfortable angle.
