How do you install crankshaft sensor?

Let’s Get Started

Disconnect the Battery.
Clear Access to the Sensor.
Inspect the Sensor Location.
Release the Electrical Connector.
Remove the Sensor Mount Bolt.
Remove the Sensor.
Match the New Crankshaft Sensor.
Installing the New Crank Position Sensor.

How do I fix code P0335?

What repairs can fix the P0335 code?

Crankshaft sensor replaced.
Repair or replace wiring harness.
PCM replacement.
Signal plate replaced.
Engine timing belt or chain fixed along with any mechanical damage from this.

How do you know if a crankshaft sensor is bad?

Common signs of a faulty crankshaft position sensor include issues starting the vehicle, intermittent stalling, and the Check Engine Light coming on.

How can you tell if a crankshaft is bad?

Symptoms of a Bad Crankshaft Position Sensor

Your Check Engine Light is Blinking.
It’s Difficult to Get Your Vehicle to Start.
Your Vehicle is Stalling and/or Backfiring.
The Engine is Making Your Vehicle Vibrate.

How do you replace the crank sensor on a Buick Century?

Disconnect the crankshaft sensor’s wiring-harness connector by pushing the plastic tabs in and pulling the plug out of the sensor. Remove the sensor bolts, using the appropriate wrench, and pull the sensor off the block. Bolt the new sensor to the block and tighten the retaining bolts to 8 foot-pounds of torque.

How does a crankshaft sensor work on a Buick?

Set the crankshaft sensor shield in place and tighten the three mounting nuts using the ratchet, ratchet extension and socket, if your Buick model is equipped with this shield. Install the balancer/pulley on the crankshaft, and tighten the bolt using the ratchet, ratchet extension and socket.

How do you remove a crankshaft position sensor?

Unscrew the three mounting nuts from the crankshaft position sensor (CKP) shield using the ratchet, ratchet extension and socket. Then remove the shield. Some Century models do not have this CKP shield.

How do you remove the harmonic balancer from a Buick?

Jack the Buick up with the floor jack abd support it with jack stands. Remove the harmonic-balancer retaining bolt, using the appropriate socket and pull the balancer off the crankshaft snout. Disconnect the crankshaft sensor’s wiring-harness connector by pushing the plastic tabs in and pulling the plug out of the sensor.

How do you remove sensor from Buick engine?

Unplug the electrical connector and unscrew the sensor mounting bolts to remove the sensor from the engine using a ratchet and socket. If you have a different model, continue with the rest of the steps.