What does code IS09141 mean?
What does code IS09141 mean?
The KWP 2000, IS09141 is the software protocol that your vehicle uses to communicate with the scanner. Code P0455 indicates that there is a large fuel tank vapor leak on your vehicle. Most likely the cause is a gas cap leak or the cap was left loose after filling your car with gas.
CAN K-Line communicate?
The K-Line is very different to a CAN Bus network and from most communication networks in general. Note 2: A CAN Bus network operates constantly as a communication network and a diagnostic network between the ECMs whilst the vehicle is in operation. The K-Line network is only intended to support diagnostic equipment.
What does ISO 9141 stand for on a car?
This is the International Standards Organization (ISO) protocol for how the control modules communicate with each other on vehicles. ISO 9141 is the standard used by ChryslerDaimler, Honda, and most Asian manufacturers. It has nothing to do with trouble codes for the specific vehicle it is connected to.
What is the ISO standard for vehicle diagnostics?
The IP-based diagnostic standard ISO 13400-3 was introduced as part of Worldwide Harmonized Vehicle Diagnostic WWH-OBD, a United Nation initiative ISO 9141-2 was the most used protocol by vehicle manufactures before the introduction of CAN.
What does ISO 9141 mean on a memoscan?
ISO 9141 is the standard used by ChryslerDaimler, Honda, and most Asian manufacturers. It has nothing to do with trouble codes for the specific vehicle it is connected to. You can’t post conmments that contain an email address.
What does code 9141 on autoxone scanner mean?
The code 9141 means your code reader isn’t connected properly. 23 people found this helpful. I am puzzled with this Maxima! Recently tuned up with new coil packs, new air flow mass sensor, and plugs! It show code ISO 9141 on scanner and autoxone diagnosed it needs a tune up. Should I change PCV valve and air filter.
This is the International Standards Organization (ISO) protocol for how the control modules communicate with each other on vehicles. ISO 9141 is the standard used by ChryslerDaimler, Honda, and most Asian manufacturers. It has nothing to do with trouble codes for the specific vehicle it is connected to.
The code 9141 means your code reader isn’t connected properly. 23 people found this helpful. I am puzzled with this Maxima! Recently tuned up with new coil packs, new air flow mass sensor, and plugs! It show code ISO 9141 on scanner and autoxone diagnosed it needs a tune up. Should I change PCV valve and air filter.
What does iso9141 mean on a can OBD II memoscan?
It is a communications protocol typically used to communicate between your car and an OBD machine (On Board Diagnostics), which can read faults on your car. My info shows it having something to do with the fuel pump. Hope this helps. Why is my car running fine, but the check engine light came on? The code reader I have shows ISO9141.
What does code 9141 mean on my maxima?
30 people found this helpful. The code 9141 means your code reader isn’t connected properly. 23 people found this helpful. I am puzzled with this Maxima! Recently tuned up with new coil packs, new air flow mass sensor, and plugs! It show code ISO 9141 on scanner and autoxone diagnosed it needs a tune up.
