How good are Duramax diesels?
How good are Duramax diesels?
The result is remarkably strong low-end acceleration, though power does flatten when passing from highway speeds. The engine is remarkably smooth, too, especially when mated to the nearly seamless 10-speed automatic. Duramax-equipped Silverados boast a 1,870 pound payload, and 9,300 pounds of towing capacity.
Why does my Duramax engine have white smoke at idle?
A common issue with the GM 6.6L LB7 Duramax engine is white smoke at idle. Worn and damaged injectors are often the cause however there are other causes and considerations that should be looked at prior to injector replacement. 1. Remove IGN 1 relay. 2.
How much power does a Duramax Diesel have?
Power was at an all-time high coming in at 397hp and 765 pounds of torque, and in order to provide this much power while still keeping pollutants low, GM needed to be able to increase the pressure in the fuel system to levels above what the tried-and-true CP3 could safely deliver.
Are there any problems with the LLY Duramax?
In terms of LLY injector problems, GM had sorted out the internal failures with the 2004 ½ redesign, but the LLY Duramax would occasionally exhibit a trouble code for the injectors, but in most cases it turned out to be an issue with the injector harness rubbing through and causing a short or open in the wiring.
Why is my Duramax diesel engine not working?
The trucks computer keeps track of how much fuel needs to be added or subtracted from each individual cylinder to make the engine run smoothly, and this value is called the balance rate. If one cylinder is contributing too much or not as much as the rest, the cause is usually a bad injector and the cure is a replacement.
How to get rid of white smoke from a Duramax engine?
1. Remove IGN 1 relay. 2. Remove the glow plug from the suspect cylinder (s). 3. Crank the engine and check for fuel spray coming out of the glow plug hole. Caution: Make sure you are not in front of the glow plug hole during this process. 4. Replace any injectors on the cylinders that spray fuel.
What to do if your Duramax has a cold start?
Perform a glow plug system and intake air heater check even if there is no complaint of a cold start problem. 1. Engine compression. 2. Dilution of the oil with fuel. 3. Engine coolant temperature sensor. 4. Rail pressure sensor. 5. Proper fuel supply to the high-pressure pump.
Where does the coolant go in a Duramax?
1. Coolant may enter the cylinder from a damaged seal between the fuel injector sleeve and the cylinder head. The injector sleeve is often dislodged during an injector removal. 2. Remove the glow plugs and the IGN 1 relay and pressurize the cooling system to 15-17 PSI. 3.
