What should the idle time be on a Chevy Malibu?

What should the idle time be on a Chevy Malibu?

1. Start and idle the engine in PARK for 3 minutes. 2. With a scan tool, monitor desired and actual RPM. 3. The ECM will start to learn the new idle cells and Desired RPM should start to decrease. 4. Ignition OFF for 60 seconds. 5. Start and idle the engine in PARK for 3 minutes. 6. After the 3 minute run time the engine should be idling normal.

What should the engine speed be on a Chevy Malibu?

• The engine speed is between 450-4,000 RPM. • The manifold absolute pressure (MAP) is greater than 5 kPa. • The mass air flow (MAF) is greater than 2 g/s. • The ignition 1 voltage is greater than 10 volts. Throttle Learn Important: Do NOT perform this procedure if DTCs are set.

What causes a Chevy Malibu to go out?

OOps most likely fouled up one of the servo motors in the body, try a parts store and get the code pulled and write it down then repost back here and we can go from there. 4 people found this helpful. Welp… I put a brand new alternator in and my car just went out.

What is the lean code on a Chevy Malibu?

The P0010 is the camshaft actuator circuit bank 1 and the P0171 is lean bank 1. So cleaning the throttle body would only cause the lean code to get stronger. Have you performed the throttle body relearn procedures?

1. Start and idle the engine in PARK for 3 minutes. 2. With a scan tool, monitor desired and actual RPM. 3. The ECM will start to learn the new idle cells and Desired RPM should start to decrease. 4. Ignition OFF for 60 seconds. 5. Start and idle the engine in PARK for 3 minutes. 6. After the 3 minute run time the engine should be idling normal.

Why is my Chevy Malibu idling high and spudding?

My 2008 chevy malibu is idling high and spudding whn i pull off can someone help 7 people found this helpful. Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus.

OOps most likely fouled up one of the servo motors in the body, try a parts store and get the code pulled and write it down then repost back here and we can go from there. 4 people found this helpful. Welp… I put a brand new alternator in and my car just went out.

What should the throttle pressure be on a Chevy Malibu?

• The manifold absolute pressure (MAP) is greater than 5 kPa. • The mass air flow (MAF) is greater than 2 g/s. • The ignition 1 voltage is greater than 10 volts. Throttle Learn Important: Do NOT perform this procedure if DTCs are set. Refer to Diagnostic Trouble Code (DTC) List – Vehicle. 1. Start and idle the engine in PARK for 3 minutes. 2.

My 2008 chevy malibu is idling high and spudding whn i pull off can someone help 7 people found this helpful. Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus.

• The manifold absolute pressure (MAP) is greater than 5 kPa. • The mass air flow (MAF) is greater than 2 g/s. • The ignition 1 voltage is greater than 10 volts. Throttle Learn Important: Do NOT perform this procedure if DTCs are set. Refer to Diagnostic Trouble Code (DTC) List – Vehicle. 1. Start and idle the engine in PARK for 3 minutes. 2.