When did the fourth generation Chevy C / K come out?
When did the fourth generation Chevy C / K come out?
For 1988, the fourth-generation C/K was introduced, including (nominal) 1⁄2 -ton, 3⁄4 -ton, and 1-ton pickup trucks and chassis cabs. In a nomenclature revision, GM adopted the 1500/2500/3500 payload series (previously used by GMC) for all full-size trucks (the Rounded-Line R/V series would do so for 1989).
When did GMC truck and coach become part of GM?
In 1981, GMC Truck & Coach Division became part of GM Worldwide Truck & Bus Group. Bus production ended in May 1987 and the division name was changed from GMC Truck & Coach to GMC Truck Division.
Where was the first GMC truck made in the US?
GMC maintained three manufacturing locations in Pontiac, Michigan, Oakland, California, and St. Louis, Missouri. In 1916, a GMC Truck crossed the country from Seattle to New York City in thirty days, and in 1926, a 2-ton GMC truck was driven from New York to San Francisco in five days and 30 minutes.
How long does it take to drive a GMC Truck?
In 1916, a GMC Truck crossed the country from Seattle to New York City in thirty days, and in 1926, a 2-ton GMC truck was driven from New York to San Francisco in five days and 30 minutes.
What’s the code for a 1989 GM 4.3L engine?
I have an 1989 G.M. 4.3L engine code “Z” that I need to adjust the valves on please! Preferably a procedure on a cold engine. I can do them hot if I have to, but I don’t want the mess.
Are there any problems with the GMC Sierra 1500?
302-horsepower 4.8L V8 4-speed automatic 4WD w/low range service traction control light was coming on. The vehicle wouldn’t go over 35 mph. Battery disconnect reset the problem temporarily It was actually a problem with the throttle body. Found out later it was a recall. Replaced coil and plug wire for Cylinder 6.
What kind of engine does a GMC Sierra 1500 have?
The repair cost chart excludes repairs made under warranty, do-it-yourself repairs, and repair trips that include maintenance. 355-horsepower 5.3L V8 8-speed shiftable automatic 4WD w/low range Gas Pedal Flex. When pressing on accelerator, the pedal would creak and pop. A new pedal bracket was installed which resolved the issue.
What are the most common GMC truck problems?
One of the most common 2007-2013 GMC and Chevy truck problems owners experience is excessive oil consumption. This problem led vehicle buyers to launch a class-action lawsuit against GM, which alleged 2010-2013 vehicles with Generation IV 5.3 Liter V8 Vortec 5300 engines were defective.
Where was the fourth generation Chevy truck made?
Over nearly a 14-year production run, the fourth-generation C/K was assembled by GM in multiple facilities in the United States, Canada, and Mexico. The development of the fourth-generation C/K began in the early 1980s, with design operations headed by General Motors Truck and Bus Group.
What kind of engine did GMC pickups have in 1987?
Only a few 30/35 series chassis cab models offered carbureted 292, 350 and 454 engines, and those were the only models that did not use catalytic converters for 1987 on. Note: The above applies only to U.S. vehicles.
What was the emissions limit for a Chevy truck in 1979?
For 1979 through the current day, the dividing line between light and heavy duty emissions was raised from 6,000 lbs GVWR to 8,500 lbs GVWR, forcing more trucks to comply with the stricter emissions standards than previously.
