How do you change a throttle position?
How do you change a throttle position?
How to Replace a Throttle Position Sensor
- Materials Needed.
- Step 1: Locate the sensor.
- Step 2: Disconnect the negative battery cable.
- Step 3: Remove the sensor electrical connector.
- Step 4: Remove the sensor mounting screws.
- Step 5: Remove the sensor.
- Step 1: Install the new sensor.
How do you remove a throttle position sensor?
Part 1 of 2: Removing the throttle position sensor. Step 1: Locate the sensor. The throttle position sensor is mounted to the throttle body on top of the engine. Step 2: Disconnect the negative battery cable. Disconnect the negative battery cable and set it aside. Step 3: Remove the sensor electrical connector.
How is the throttle pedal connected to the PCM?
The throttle pedal has a position sensor (basically just a potentiometer) which is directly connected to the instrument cluster. The instrument cluster converts the analog sensor signal to a digital CANbus signal and communicates this signal to the PCM.
Is there a way to reset the throttle body?
This method is almost foolproof as long as all ECU control parameters are within their normal ranges. Resetting The Throttle Body Calibration (this step is conditional) A Rough Idle or a SES can sometimes be caused by a change in the throttle body position sensor calibration.
How to change the accelerator pedal release position?
Accelerator Pedal Release Position Learning Procedure. Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.
Part 1 of 2: Removing the throttle position sensor. Step 1: Locate the sensor. The throttle position sensor is mounted to the throttle body on top of the engine. Step 2: Disconnect the negative battery cable. Disconnect the negative battery cable and set it aside. Step 3: Remove the sensor electrical connector.
How to relearn throttle on a new battery?
Throttle relearn procedure/New battery/Won’t Idle or Run Step 1: Turn the key to the ON position but do not start. Step 2: Press the accelerator pedal ALL THE WAY to the floor and hold it for 40 seconds. Step 3: Release the accelerator pedal ALL THE WAY and count for 35 seconds. Step 4: Press the
Accelerator Pedal Release Position Learning Procedure. Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.
This method is almost foolproof as long as all ECU control parameters are within their normal ranges. Resetting The Throttle Body Calibration (this step is conditional) A Rough Idle or a SES can sometimes be caused by a change in the throttle body position sensor calibration.
