How do I connect my scan tool to my car?
How do I connect my scan tool to my car?
Plug the standard OBD2 connector into the vehicle’s port located under the driver’s side of the dashboard. Turn on the car to power the scan tool or code reader. If necessary, enter any vehicle-specific information requested. Many tools will ask for the Vehicle Identification Number (VIN).
How to fix a car that won’t communicate with a scan tool?
This feature is not available right now. Please try again later. Scotty Kilmer, mechanic for the last 48 years, shows how to fix a broken car the won’t communicate with a scan tool so you can’t get any information on the problem. Sometimes it’s as easy as just disconnecting parts to find the problem. 1. Actron Scan Tool: http://amzn.to/2ngeCQJ 2.
What to do if the OBD II scanner doesn’t communicate with the vehicle?
What to do if the OBD II scanner doesn’t communicate with the vehicle. TEST 1: Connect the positive DMM lead to DLC pin 4 and the negative DMM lead to the negative battery terminal, using jumper wires if necessary. Do not connect to the body or chassis ground but to the battery terminal directly.
Why is my scan port not working on my car?
Remember that your car or truck might have more than one fuse box. This should be covered in your owner’s manual or a proper service manual. Another reason for getting no reading is that the scan port has become clogged with dust after years of not being used.
Which is the best tool to diagnose electrical problems?
The power probe electrical tester has an easy to use power test feature that can detect whether the circuit has a resistive or bad ground, or if it’s a complete circuit.
This feature is not available right now. Please try again later. Scotty Kilmer, mechanic for the last 48 years, shows how to fix a broken car the won’t communicate with a scan tool so you can’t get any information on the problem. Sometimes it’s as easy as just disconnecting parts to find the problem. 1. Actron Scan Tool: http://amzn.to/2ngeCQJ 2.
What to do if the OBD II scanner doesn’t communicate with the vehicle. TEST 1: Connect the positive DMM lead to DLC pin 4 and the negative DMM lead to the negative battery terminal, using jumper wires if necessary. Do not connect to the body or chassis ground but to the battery terminal directly.
Remember that your car or truck might have more than one fuse box. This should be covered in your owner’s manual or a proper service manual. Another reason for getting no reading is that the scan port has become clogged with dust after years of not being used.
The power probe electrical tester has an easy to use power test feature that can detect whether the circuit has a resistive or bad ground, or if it’s a complete circuit.
